Kyocera FSC5400DN Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Kyocera FSC5400DN Top Searches

These results are ranked by popularity.

Error
F050Description: Engine PWB ROM checksum error
4204Description: Laser output error (Yellow) The pin photo signal (PDN) is not output from PD PWB Y for one second while laser is emitted.
1010Description: Lift motor error When the lift motor is driven, the lift motor over-current detection signal is detected continuously for 50 times (5 s) at 100 ms intervals. After the lift motor is driven, the ON status of lift limit sensor cannot be detect
6120Description: Abnormally high temperature fuser heater lamp 2 The fuser thermistor 1 detects a temperature higher than 240°C/464°F. By the activation of the high temperature error detection circuit (230°C/446°F or more) of fuser thermistor 2, the illumina
7411Description: Drum unit K non-installing error The EEPROM of drum PWB K does not communicate normally. Incompatible drum unit K is installed.

Kyocera FSC5400DN Common Errors

The most common error codes.

Error
F050Description: Engine PWB ROM checksum error
4204Description: Laser output error (Yellow) The pin photo signal (PDN) is not output from PD PWB Y for one second while laser is emitted.
1010Description: Lift motor error When the lift motor is driven, the lift motor over-current detection signal is detected continuously for 50 times (5 s) at 100 ms intervals. After the lift motor is driven, the ON status of lift limit sensor cannot be detect
6120Description: Abnormally high temperature fuser heater lamp 2 The fuser thermistor 1 detects a temperature higher than 240°C/464°F. By the activation of the high temperature error detection circuit (230°C/446°F or more) of fuser thermistor 2, the illumina
7411Description: Drum unit K non-installing error The EEPROM of drum PWB K does not communicate normally. Incompatible drum unit K is installed.
F050Description: Engine PWB ROM checksum error
4204Description: Laser output error (Yellow) The pin photo signal (PDN) is not output from PD PWB Y for one second while laser is emitted.
1010Description: Lift motor error When the lift motor is driven, the lift motor over-current detection signal is detected continuously for 50 times (5 s) at 100 ms intervals. After the lift motor is driven, the ON status of lift limit sensor cannot be detect
6120Description: Abnormally high temperature fuser heater lamp 2 The fuser thermistor 1 detects a temperature higher than 240°C/464°F. By the activation of the high temperature error detection circuit (230°C/446°F or more) of fuser thermistor 2, the illumina
7411Description: Drum unit K non-installing error The EEPROM of drum PWB K does not communicate normally. Incompatible drum unit K is installed.