Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Kyocera DC6090 Top Searches

These results are ranked by popularity.

Error
C852Description: Sorter stapler motor problem--A block signal fails to be input from the home sensor within 100 ms after the stapler motor has turned on. Home signal fails to be input within 250 ms after the block signal has been emitted.
C521Description: Separation high-voltage problem--The separation high voltage short detection signal is generated by the transfer charger high-voltage PCB for 5 s.
C630Description: Fixing unit thermistor wire broken--The data generated by the fixing unit thermistor remains at F1H or above for longer than two minutes while fixing unit heaters M and S are on.
C010Description: Backup memory problem--The specified data was not written into NVRAM.
C720Description: Drum thermistor wire broken--The signal from the drum thermistor remains high for 5 s.

Kyocera DC6090 Common Errors

The most common error codes.

Error
C852Description: Sorter stapler motor problem--A block signal fails to be input from the home sensor within 100 ms after the stapler motor has turned on. Home signal fails to be input within 250 ms after the block signal has been emitted.
C521Description: Separation high-voltage problem--The separation high voltage short detection signal is generated by the transfer charger high-voltage PCB for 5 s.
C630Description: Fixing unit thermistor wire broken--The data generated by the fixing unit thermistor remains at F1H or above for longer than two minutes while fixing unit heaters M and S are on.
C010Description: Backup memory problem--The specified data was not written into NVRAM.
C720Description: Drum thermistor wire broken--The signal from the drum thermistor remains high for 5 s.
C852Description: Sorter stapler motor problem--A block signal fails to be input from the home sensor within 100 ms after the stapler motor has turned on. Home signal fails to be input within 250 ms after the block signal has been emitted.
C521Description: Separation high-voltage problem--The separation high voltage short detection signal is generated by the transfer charger high-voltage PCB for 5 s.
C630Description: Fixing unit thermistor wire broken--The data generated by the fixing unit thermistor remains at F1H or above for longer than two minutes while fixing unit heaters M and S are on.
C010Description: Backup memory problem--The specified data was not written into NVRAM.
C720Description: Drum thermistor wire broken--The signal from the drum thermistor remains high for 5 s.