Konica-Minolta Bizhub C364e Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Konica-Minolta Bizhub C364e Top Searches

These results are ranked by popularity.

Error
C2552Description: Abnormally high toner density detected cyan TCR sensor The TC ratio of the toner determined by the toner replenishment control is detected to be the predetermined value or over for consecutive times.
C1106Description: Stapler movement motor’s malfunction • The stapler home sensor (PS110) is not unblocked after the laps of given time after it started operating from the home position. • The stapler home sensor (PS110) is not unbl
C6913Description: DSC Bus check NG2-2 When MFP detects that DSC board/2 (back side) is not properly installed.
C3926Description: Fusing sensor wire breaks detection (Middle of the heating roller) • After a predetermined period of time after the warm-up stage is started, the heating roller thermistor/2 (TH2) voltage does not decrease by predetermined steps (temperatur
CA053Description: Controller start failure A controller start failure is detected in the controller interface.

Konica-Minolta Bizhub C364e Common Errors

The most common error codes.

Error
C2552Description: Abnormally high toner density detected cyan TCR sensor The TC ratio of the toner determined by the toner replenishment control is detected to be the predetermined value or over for consecutive times.
C1106Description: Stapler movement motor’s malfunction • The stapler home sensor (PS110) is not unblocked after the laps of given time after it started operating from the home position. • The stapler home sensor (PS110) is not unbl
C6913Description: DSC Bus check NG2-2 When MFP detects that DSC board/2 (back side) is not properly installed.
C3926Description: Fusing sensor wire breaks detection (Middle of the heating roller) • After a predetermined period of time after the warm-up stage is started, the heating roller thermistor/2 (TH2) voltage does not decrease by predetermined steps (temperatur
CA053Description: Controller start failure A controller start failure is detected in the controller interface.
C2552Description: Abnormally high toner density detected cyan TCR sensor The TC ratio of the toner determined by the toner replenishment control is detected to be the predetermined value or over for consecutive times.
C1106Description: Stapler movement motor’s malfunction • The stapler home sensor (PS110) is not unblocked after the laps of given time after it started operating from the home position. • The stapler home sensor (PS110) is not unbl
C6913Description: DSC Bus check NG2-2 When MFP detects that DSC board/2 (back side) is not properly installed.
C3926Description: Fusing sensor wire breaks detection (Middle of the heating roller) • After a predetermined period of time after the warm-up stage is started, the heating roller thermistor/2 (TH2) voltage does not decrease by predetermined steps (temperatur
CA053Description: Controller start failure A controller start failure is detected in the controller interface.