Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Konica-Minolta Bizhub C350 Top Searches

These results are ranked by popularity.

Error
C13C8Description: New Transfer Cleaner Unit resetting failure • A new installation is not detected when a new Transfer Cleaner Unit (Image Transfer Belt Unit) is installed.
C0B55Description: Finishing option Staple/Folding Motor malfunction
C0202Description: Magenta PC Drum Charge Corona malfunction
C3310Description: CCD clamp/gain adjustment failure • The adjustment value is 0 or 255 during a CCD clamp adjustment. • The peak value of the output data is 64 or less during a CCD gain adjustment.
C0F32Description: Abnormally low toner density detected Magenta ATDC Sensor • T/C 0.21 % or less is detected ten consecutive times in the Developing Unit as validated through the toner replenishing amount determination control.

Konica-Minolta Bizhub C350 Common Errors

The most common error codes.

Error
C13C8Description: New Transfer Cleaner Unit resetting failure • A new installation is not detected when a new Transfer Cleaner Unit (Image Transfer Belt Unit) is installed.
C0B55Description: Finishing option Staple/Folding Motor malfunction
C0202Description: Magenta PC Drum Charge Corona malfunction
C3310Description: CCD clamp/gain adjustment failure • The adjustment value is 0 or 255 during a CCD clamp adjustment. • The peak value of the output data is 64 or less during a CCD gain adjustment.
C0F32Description: Abnormally low toner density detected Magenta ATDC Sensor • T/C 0.21 % or less is detected ten consecutive times in the Developing Unit as validated through the toner replenishing amount determination control.
C0202Description: Magenta PC Drum Charge Corona malfunction
C13C8Description: New Transfer Cleaner Unit resetting failure • A new installation is not detected when a new Transfer Cleaner Unit (Image Transfer Belt Unit) is installed.
C0B55Description: Finishing option Staple/Folding Motor malfunction
C0521Description: Fusing Pressure Roller abnormally high temperature • A temperature of 190 °C or more of the Fusing Pressure Roller is detected for 1 sec. or more before the start of the heater temperature control. • A temperature of 215 °C or more of the
C3310Description: CCD clamp/gain adjustment failure • The adjustment value is 0 or 255 during a CCD clamp adjustment. • The peak value of the output data is 64 or less during a CCD gain adjustment.