Konica-Minolta Bizhub C250i Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Konica-Minolta Bizhub C250i Top Searches

These results are ranked by popularity.

Error
C8101Description: Before reading pressure welding alienation mechanism (When DF-632 or DF-714 is installed) • During a pressure motion being performed, the reading roll position sensor (PS11) output does not change from H to L. • Du
E3-1Description: Target device I2C Diagnosis item TPM Reason of error Connection failure Parts defect
72-25, 72-26Description: Misfeed at SD paper exit section 72-25 The fold exit sensor (PS12) is not turned ON by the paper even after the lapse of a given period of time after the half-fold exit operation started. 72-26
C7202Description: Tray 2 paper feed clutch failure After starting the clutch, an error is detected for the malfunction detection signal.
CFE1# ... CFE2#Description: CFE1# - CFE2#: Abort code

Konica-Minolta Bizhub C250i Common Errors

The most common error codes.

Error
C8101Description: Before reading pressure welding alienation mechanism (When DF-632 or DF-714 is installed) • During a pressure motion being performed, the reading roll position sensor (PS11) output does not change from H to L. • Du
E3-1Description: Target device I2C Diagnosis item TPM Reason of error Connection failure Parts defect
72-25, 72-26Description: Misfeed at SD paper exit section 72-25 The fold exit sensor (PS12) is not turned ON by the paper even after the lapse of a given period of time after the half-fold exit operation started. 72-26
C7202Description: Tray 2 paper feed clutch failure After starting the clutch, an error is detected for the malfunction detection signal.
CFE1# ... CFE2#Description: CFE1# - CFE2#: Abort code
C8101Description: Before reading pressure welding alienation mechanism (When DF-632 or DF-714 is installed) • During a pressure motion being performed, the reading roll position sensor (PS11) output does not change from H to L. • Du
E3-1Description: Target device I2C Diagnosis item TPM Reason of error Connection failure Parts defect
72-25, 72-26Description: Misfeed at SD paper exit section 72-25 The fold exit sensor (PS12) is not turned ON by the paper even after the lapse of a given period of time after the half-fold exit operation started. 72-26
C7202Description: Tray 2 paper feed clutch failure After starting the clutch, an error is detected for the malfunction detection signal.
CFE1# ... CFE2#Description: CFE1# - CFE2#: Abort code