Select an Error Code or Type an Error Code to begin searching
| Error |
|---|
| Error |
|---|
These results are ranked by popularity.
| Error | |
|---|---|
| 121.25 | Description: After line voltage detection, control did not roll over to steady state control in time. |
| 840.02 | Description: The scanner is disabled and can’t be used. This message is posted when the MFP PORs. Enter the configuration menu, and reenable the scanner module. |
| 959.23 | Description: Pensive self test failed during initialization. Replace the controller board. |
| 321.51 | Description: ACM motor no first encoder |
| 912.xx | Description: Unrecoverable Engine firmware error POR the machine. If the error re-occurs, then update the firmware. If the error remians, then replace the controller board. |
The most common error codes.
| Error | |
|---|---|
| 121.25 | Description: After line voltage detection, control did not roll over to steady state control in time. |
| 840.02 | Description: The scanner is disabled and can’t be used. This message is posted when the MFP PORs. Enter the configuration menu, and reenable the scanner module. |
| 959.23 | Description: Pensive self test failed during initialization. Replace the controller board. |
| 321.51 | Description: ACM motor no first encoder |
| 912.xx | Description: Unrecoverable Engine firmware error POR the machine. If the error re-occurs, then update the firmware. If the error remians, then replace the controller board. |
| 121.25 | Description: After line voltage detection, control did not roll over to steady state control in time. |
| 321.51 | Description: ACM motor no first encoder |
| 840.02 | Description: The scanner is disabled and can’t be used. This message is posted when the MFP PORs. Enter the configuration menu, and reenable the scanner module. |
| 959.23 | Description: Pensive self test failed during initialization. Replace the controller board. |
| 132.02 | Description: TDS baseline too high. |