Error |
---|
These results are ranked by popularity.
Error | |
---|---|
CA052 | Description: MIO Device Failure - The MIO device does not operate properly |
C11A5 | Description: Saddle In & Out Guide Motor Failure - - See SD-507 service manual. |
C2557 | Description: ATDC Sensor Failure - The scanning value of the ATDC Sensor is less than 7 % while the IU Motor is turning. - The scanning value of the ATDC Sensor is more than 19 % while the IU Motor is turning. |
C0001 | Description: LCT Communication Failure - Due to a software malfunction, etc., the time on the watchdog timer has run out and a reset is performed. |
C4002 | Description: HSYNC Detection Failure - No SOS falling edges are detected within the set period of time after laser emission began while the Polygon Motor is turning. - No SOS falling edges are detected while VIA remains ON. |
The most common error codes.
Error | |
---|---|
CA052 | Description: MIO Device Failure - The MIO device does not operate properly |
C11A5 | Description: Saddle In & Out Guide Motor Failure - - See SD-507 service manual. |
C2557 | Description: ATDC Sensor Failure - The scanning value of the ATDC Sensor is less than 7 % while the IU Motor is turning. - The scanning value of the ATDC Sensor is more than 19 % while the IU Motor is turning. |
C0001 | Description: LCT Communication Failure - Due to a software malfunction, etc., the time on the watchdog timer has run out and a reset is performed. |
C4002 | Description: HSYNC Detection Failure - No SOS falling edges are detected within the set period of time after laser emission began while the Polygon Motor is turning. - No SOS falling edges are detected while VIA remains ON. |
CA052 | Description: MIO Device Failure - The MIO device does not operate properly |
C11A5 | Description: Saddle In & Out Guide Motor Failure - - See SD-507 service manual. |
C2557 | Description: ATDC Sensor Failure - The scanning value of the ATDC Sensor is less than 7 % while the IU Motor is turning. - The scanning value of the ATDC Sensor is more than 19 % while the IU Motor is turning. |
C0001 | Description: LCT Communication Failure - Due to a software malfunction, etc., the time on the watchdog timer has run out and a reset is performed. |
C4002 | Description: HSYNC Detection Failure - No SOS falling edges are detected within the set period of time after laser emission began while the Polygon Motor is turning. - No SOS falling edges are detected while VIA remains ON. |