Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Konica-Minolta Bizhub 3320 Top Searches

These results are ranked by popularity.

Error
959.23Description: Pensive self test failed during initialization. Replace the controller board.
840.02Description: The scanner is disabled and can’t be used. This message is posted when the MFP PORs. Enter the configuration menu, and reenable the scanner module.
321.51Description: ACM motor no first encoder
121.25Description: After line voltage detection, control did not roll over to steady state control in time.
912.xxDescription: Unrecoverable Engine firmware error POR the machine. If the error re-occurs, then update the firmware. If the error remians, then replace the controller board.

Konica-Minolta Bizhub 3320 Common Errors

The most common error codes.

Error
959.23Description: Pensive self test failed during initialization. Replace the controller board.
840.02Description: The scanner is disabled and can’t be used. This message is posted when the MFP PORs. Enter the configuration menu, and reenable the scanner module.
321.51Description: ACM motor no first encoder
121.25Description: After line voltage detection, control did not roll over to steady state control in time.
912.xxDescription: Unrecoverable Engine firmware error POR the machine. If the error re-occurs, then update the firmware. If the error remians, then replace the controller board.
959.23Description: Pensive self test failed during initialization. Replace the controller board.
840.02Description: The scanner is disabled and can’t be used. This message is posted when the MFP PORs. Enter the configuration menu, and reenable the scanner module.
321.51Description: ACM motor no first encoder
121.25Description: After line voltage detection, control did not roll over to steady state control in time.
912.xxDescription: Unrecoverable Engine firmware error POR the machine. If the error re-occurs, then update the firmware. If the error remians, then replace the controller board.