Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Konica-Minolta Magicolor 2430DL Top Searches

These results are ranked by popularity.

Error
2CHDescription: Memory mounting failure • Mounting of the parameter chip on the Mechanical Control Board is faulty.
04HDescription: Mechanical Control Board malfunction • Communications with the M/C expansion IO G/A (IC on the Mechanical Control Board) are not properly carried out.
18HDescription: Heating Roller warm-up failure • The Thermistor does not detect a predetermined temperature value even after the lapse of a predetermined period of time after the current warm-up cycle has been started and the current warm-up cycle is thus
05HDescription: Flash ROM malfunction • Firmware upgrading has failed.
19HDescription: Abnormally low Heating Roller temperature • The temperature detected by the Thermistor remains lower than a predetermined value for a predetermined period of time.

Konica-Minolta Magicolor 2430DL Common Errors

The most common error codes.

Error
2CHDescription: Memory mounting failure • Mounting of the parameter chip on the Mechanical Control Board is faulty.
04HDescription: Mechanical Control Board malfunction • Communications with the M/C expansion IO G/A (IC on the Mechanical Control Board) are not properly carried out.
18HDescription: Heating Roller warm-up failure • The Thermistor does not detect a predetermined temperature value even after the lapse of a predetermined period of time after the current warm-up cycle has been started and the current warm-up cycle is thus
05HDescription: Flash ROM malfunction • Firmware upgrading has failed.
19HDescription: Abnormally low Heating Roller temperature • The temperature detected by the Thermistor remains lower than a predetermined value for a predetermined period of time.
2CHDescription: Memory mounting failure • Mounting of the parameter chip on the Mechanical Control Board is faulty.
04HDescription: Mechanical Control Board malfunction • Communications with the M/C expansion IO G/A (IC on the Mechanical Control Board) are not properly carried out.
18HDescription: Heating Roller warm-up failure • The Thermistor does not detect a predetermined temperature value even after the lapse of a predetermined period of time after the current warm-up cycle has been started and the current warm-up cycle is thus
05HDescription: Flash ROM malfunction • Firmware upgrading has failed.
19HDescription: Abnormally low Heating Roller temperature • The temperature detected by the Thermistor remains lower than a predetermined value for a predetermined period of time.