Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Konica-Minolta Bizhub 223 Top Searches

These results are ranked by popularity.

Error
C1181Description: Malfunctioning of belt up/ down movement • The belt position sensor (PS13) is not turned OFF after the set period of time has elapsed after the belt retract solenoid (SD5) is turned ON. • The belt position sensor
C3421Description: Fusing heaters trouble (center) • Detected temperature of the heating roller thermistor (TH2; center) does not go up a given range of temperature even after a lapse of given period of time at warm up. • The warm-up is not completed even aft
CC153Description: ROM contents error upon startup (PRT) • A fault is detected in a sequence of ROM contents check of the PRCB during starting.
C5602Description: FPGA configuration error • When a configuration check is performed on the extended IC chip (FPGA) located on the printer control board (PRCB), error is detected.
C11A1Description: Exit roller pressure/ retraction malfunction • The pick up roller position sensor (PS12) is turned neither ON nor OFF even after the set period of time has elapsed after the pick up roller position motor (M1) is t

Konica-Minolta Bizhub 223 Common Errors

The most common error codes.

Error
C1181Description: Malfunctioning of belt up/ down movement • The belt position sensor (PS13) is not turned OFF after the set period of time has elapsed after the belt retract solenoid (SD5) is turned ON. • The belt position sensor
C3421Description: Fusing heaters trouble (center) • Detected temperature of the heating roller thermistor (TH2; center) does not go up a given range of temperature even after a lapse of given period of time at warm up. • The warm-up is not completed even aft
CC153Description: ROM contents error upon startup (PRT) • A fault is detected in a sequence of ROM contents check of the PRCB during starting.
C5602Description: FPGA configuration error • When a configuration check is performed on the extended IC chip (FPGA) located on the printer control board (PRCB), error is detected.
C11A1Description: Exit roller pressure/ retraction malfunction • The pick up roller position sensor (PS12) is turned neither ON nor OFF even after the set period of time has elapsed after the pick up roller position motor (M1) is t
CC153Description: ROM contents error upon startup (PRT) • A fault is detected in a sequence of ROM contents check of the PRCB during starting.
C3421Description: Fusing heaters trouble (center) • Detected temperature of the heating roller thermistor (TH2; center) does not go up a given range of temperature even after a lapse of given period of time at warm up. • The warm-up is not completed even aft
C1181Description: Malfunctioning of belt up/ down movement • The belt position sensor (PS13) is not turned OFF after the set period of time has elapsed after the belt retract solenoid (SD5) is turned ON. • The belt position sensor
C11A1Description: Exit roller pressure/ retraction malfunction • The pick up roller position sensor (PS12) is turned neither ON nor OFF even after the set period of time has elapsed after the pick up roller position motor (M1) is t
C0001Description: LCT communication error • Due to malfunctioning of the software or other causes, the watchdog timer triggers a reset when time is up.