Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Konica-Minolta bizhub Pro 1050P Top Searches

These results are ranked by popularity.

Error
SC46-01Description: APC abnormality. While in the image write, the APC is not applicable for the correction of the sub scan beam. Due to the 12V DC power for the laser drive not supplied, the MPC being wrong and the laser defective, the laser does not light up.
SC46-91Description: Header readout address abnormality.
SC32-20Description: The rotation of the paper exit cooling fans /2 (FM10) and /3 (FM28) is checked. An abnormal condition occurs with the FM10 EM signal a specified period of time after the FM10 is turned ON. This abnormal condition recurs even a specified peri
SC18-52Description: When the upper limit sensor /3 (PS83) is OFF, the PS83 does not turn ON within 20 seconds after the paper lift motor /3 (M44) turns ON for lifting operation. And at this time, an error detection signal (blowout of a fuse) is detected.
SC53-04Description: The 24V power source for the key counter (CNT2) is checked. When the CNT2 is turned ON from OFF, an error detection signal (blowout of a fuse/24V cut off) is detected.

Konica-Minolta bizhub Pro 1050P Common Errors

The most common error codes.

Error
SC46-01Description: APC abnormality. While in the image write, the APC is not applicable for the correction of the sub scan beam. Due to the 12V DC power for the laser drive not supplied, the MPC being wrong and the laser defective, the laser does not light up.
SC46-91Description: Header readout address abnormality.
SC32-20Description: The rotation of the paper exit cooling fans /2 (FM10) and /3 (FM28) is checked. An abnormal condition occurs with the FM10 EM signal a specified period of time after the FM10 is turned ON. This abnormal condition recurs even a specified peri
SC18-52Description: When the upper limit sensor /3 (PS83) is OFF, the PS83 does not turn ON within 20 seconds after the paper lift motor /3 (M44) turns ON for lifting operation. And at this time, an error detection signal (blowout of a fuse) is detected.
SC53-04Description: The 24V power source for the key counter (CNT2) is checked. When the CNT2 is turned ON from OFF, an error detection signal (blowout of a fuse/24V cut off) is detected.
SC46-01Description: APC abnormality. While in the image write, the APC is not applicable for the correction of the sub scan beam. Due to the 12V DC power for the laser drive not supplied, the MPC being wrong and the laser defective, the laser does not light up.
SC46-91Description: Header readout address abnormality.
SC32-20Description: The rotation of the paper exit cooling fans /2 (FM10) and /3 (FM28) is checked. An abnormal condition occurs with the FM10 EM signal a specified period of time after the FM10 is turned ON. This abnormal condition recurs even a specified peri
SC28-03Description: A separation leak is detected. After a separation error detection signal is detected while in the separation ON, up to 5 separation ON/OFF operations occur in succession while in 10 prints.
SC53-04Description: The 24V power source for the key counter (CNT2) is checked. When the CNT2 is turned ON from OFF, an error detection signal (blowout of a fuse/24V cut off) is detected.