Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


HP DesignJet L26500 Top Searches

These results are ranked by popularity.

Error
45.02:10Description: Rewinder inverse polarity. Rewinder inverse polarity. This message is only displayed when the printer is initializing
16.10:00Description: Curing Assembly resistors incorrect. The firmware measures the current through the Burst resistor and the steady resistor, and it checks that one is greater than the other. If the measurements detected are not as expected this could indicate
14.03:00Description: Current too high on the Curing Module. Overcurrent in Curing Module. The level of amps is over 18 amps, or the amount of current requested from the curing Module is too high.
74:04Description: Request to upgrade the firmware. This error is displayed when the current firmware does not support the installed PrintMech PCA.
26.00:10Description: Contact failure with Magenta Ink Cartridge. Bad contact detected in ISS slot 0 floater.

HP DesignJet L26500 Common Errors

The most common error codes.

Error
45.02:10Description: Rewinder inverse polarity. Rewinder inverse polarity. This message is only displayed when the printer is initializing
16.10:00Description: Curing Assembly resistors incorrect. The firmware measures the current through the Burst resistor and the steady resistor, and it checks that one is greater than the other. If the measurements detected are not as expected this could indicate
14.03:00Description: Current too high on the Curing Module. Overcurrent in Curing Module. The level of amps is over 18 amps, or the amount of current requested from the curing Module is too high.
74:04Description: Request to upgrade the firmware. This error is displayed when the current firmware does not support the installed PrintMech PCA.
26.00:10Description: Contact failure with Magenta Ink Cartridge. Bad contact detected in ISS slot 0 floater.
45.02:10Description: Rewinder inverse polarity. Rewinder inverse polarity. This message is only displayed when the printer is initializing
16.10:00Description: Curing Assembly resistors incorrect. The firmware measures the current through the Burst resistor and the steady resistor, and it checks that one is greater than the other. If the measurements detected are not as expected this could indicate
14.03:00Description: Current too high on the Curing Module. Overcurrent in Curing Module. The level of amps is over 18 amps, or the amount of current requested from the curing Module is too high.
74:04Description: Request to upgrade the firmware. This error is displayed when the current firmware does not support the installed PrintMech PCA.
26.00:10Description: Contact failure with Magenta Ink Cartridge. Bad contact detected in ISS slot 0 floater.