HP LaserJet 1000 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


HP LaserJet 1000 Top Searches

These results are ranked by popularity.

Error
126xDescription: Trailing Cable Connection Error The Trailing Cable connected to the one of the following connectors is faulty. x = 0: Connector 9. x = 1: Connector 10. x = 2: Connector 11. x = 3: Connector 12.
H03Description: Front Heater Temperature Error Temperature read by the Front Heater is abnormal (lower than -10C or higher than 70C).
0400Description: USB Register The read/write of the USB controller on the Main PCA was diagnosed and an error was detected.
11AxDescription: NVRAM Error The data in the NVRAM is incorrect.
170XDescription: Servo Motor Error The Paper-Axis or the Scan-Axis Motor moves the Carriage, but the input from the Linear Encoder Sensor does not change. x = 0: Feed System. x = 1: Carriage System. x = 2: Servo Unit.

HP LaserJet 1000 Common Errors

The most common error codes.

Error
126xDescription: Trailing Cable Connection Error The Trailing Cable connected to the one of the following connectors is faulty. x = 0: Connector 9. x = 1: Connector 10. x = 2: Connector 11. x = 3: Connector 12.
H03Description: Front Heater Temperature Error Temperature read by the Front Heater is abnormal (lower than -10C or higher than 70C).
0400Description: USB Register The read/write of the USB controller on the Main PCA was diagnosed and an error was detected.
11AxDescription: NVRAM Error The data in the NVRAM is incorrect.
170XDescription: Servo Motor Error The Paper-Axis or the Scan-Axis Motor moves the Carriage, but the input from the Linear Encoder Sensor does not change. x = 0: Feed System. x = 1: Carriage System. x = 2: Servo Unit.
126xDescription: Trailing Cable Connection Error The Trailing Cable connected to the one of the following connectors is faulty. x = 0: Connector 9. x = 1: Connector 10. x = 2: Connector 11. x = 3: Connector 12.
H03Description: Front Heater Temperature Error Temperature read by the Front Heater is abnormal (lower than -10C or higher than 70C).
0400Description: USB Register The read/write of the USB controller on the Main PCA was diagnosed and an error was detected.
11AxDescription: NVRAM Error The data in the NVRAM is incorrect.
170XDescription: Servo Motor Error The Paper-Axis or the Scan-Axis Motor moves the Carriage, but the input from the Linear Encoder Sensor does not change. x = 0: Feed System. x = 1: Carriage System. x = 2: Servo Unit.