'

Epson SC-F6000 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Epson SC-F6000 Top Searches

These results are ranked by popularity.

Error
2008Description: Wrong FLASH device error
1599Description: Oscillation error The control terminal (Vre terminal) of the ATC MOTOR driver has shorted out.
141FDescription: Lock error The pump motor was driven at a speed abnormally slower than a predetermined one during operation.• Irregular load• Pump motor encoder failure• Pump motor failure
1523Description: Roll sensor error
113Description: Reversing error The number of occurrences of reversing the CR MOTOR has reached a predetermined limit. • The polarity of CR ENCODER cable is opposite. • The polarity of CR MOTOR cable is opposite. • Slipping of the teeth of CR TIMING BELT •

Epson SC-F6000 Common Errors

The most common error codes.

Error
2008Description: Wrong FLASH device error
1599Description: Oscillation error The control terminal (Vre terminal) of the ATC MOTOR driver has shorted out.
141FDescription: Lock error The pump motor was driven at a speed abnormally slower than a predetermined one during operation.• Irregular load• Pump motor encoder failure• Pump motor failure
1523Description: Roll sensor error
113Description: Reversing error The number of occurrences of reversing the CR MOTOR has reached a predetermined limit. • The polarity of CR ENCODER cable is opposite. • The polarity of CR MOTOR cable is opposite. • Slipping of the teeth of CR TIMING BELT •
2008Description: Wrong FLASH device error
1599Description: Oscillation error The control terminal (Vre terminal) of the ATC MOTOR driver has shorted out.
141FDescription: Lock error The pump motor was driven at a speed abnormally slower than a predetermined one during operation.• Irregular load• Pump motor encoder failure• Pump motor failure
1523Description: Roll sensor error
113Description: Reversing error The number of occurrences of reversing the CR MOTOR has reached a predetermined limit. • The polarity of CR ENCODER cable is opposite. • The polarity of CR MOTOR cable is opposite. • Slipping of the teeth of CR TIMING BELT •