These results are ranked by popularity.
Error | |
---|---|
E061-0005 | Description: At time of potential control, a specific level of potential is absent. Or, the limiter goes on. The difference in potential between dark and light areas is less than 100 V. |
E677-0010 | Description: There is an external controller error. A controller for a non-Canon machine is connected. |
E020-xxA3 | Description: There is an ATR error. xx=01 for Y; xx=02 for M; xx=03 for C; xx=04 for without color distinction For ATR control, the Ref value is 960 or higher. The ATR sensor is damaged or has an open circuit. The connector has poor contact. |
E593-8001 | Description: There is an error in the punch shift motor. (punch unit) The light-receiving voltage HP sensor does not go off at time of light emission. |
E004-000E | Description: There is an error in the fixing assembly protection circuit. There is an open circuit or poor contact in the main thermistor (THM1, THM2, THM3) or sub thermistor (TH4, THM5, THM6). The AC driver PCB or the DC controller PCB has a fault. The |
The most common error codes.
Error | |
---|---|
E061-0005 | Description: At time of potential control, a specific level of potential is absent. Or, the limiter goes on. The difference in potential between dark and light areas is less than 100 V. |
E677-0010 | Description: There is an external controller error. A controller for a non-Canon machine is connected. |
E020-xxA3 | Description: There is an ATR error. xx=01 for Y; xx=02 for M; xx=03 for C; xx=04 for without color distinction For ATR control, the Ref value is 960 or higher. The ATR sensor is damaged or has an open circuit. The connector has poor contact. |
E593-8001 | Description: There is an error in the punch shift motor. (punch unit) The light-receiving voltage HP sensor does not go off at time of light emission. |
E004-000E | Description: There is an error in the fixing assembly protection circuit. There is an open circuit or poor contact in the main thermistor (THM1, THM2, THM3) or sub thermistor (TH4, THM5, THM6). The AC driver PCB or the DC controller PCB has a fault. The |
E061-0005 | Description: At time of potential control, a specific level of potential is absent. Or, the limiter goes on. The difference in potential between dark and light areas is less than 100 V. |
E677-0010 | Description: There is an external controller error. A controller for a non-Canon machine is connected. |
E020-xxA3 | Description: There is an ATR error. xx=01 for Y; xx=02 for M; xx=03 for C; xx=04 for without color distinction For ATR control, the Ref value is 960 or higher. The ATR sensor is damaged or has an open circuit. The connector has poor contact. |
E593-8001 | Description: There is an error in the punch shift motor. (punch unit) The light-receiving voltage HP sensor does not go off at time of light emission. |
E004-000E | Description: There is an error in the fixing assembly protection circuit. There is an open circuit or poor contact in the main thermistor (THM1, THM2, THM3) or sub thermistor (TH4, THM5, THM6). The AC driver PCB or the DC controller PCB has a fault. The |