These results are ranked by popularity.
| Error | |
|---|---|
| E002-0005 | Description: Insufficient temperature rise of fixing unit When the fixing main thermistor fails to reach 150 deg C within the prescribed period of time after reaching 130 deg C during warm-up |
| E590-8002 | Description: When the puncher cannot detect the punch home position sensor after motor drive has stopped during the initial operation of the punch motor |
| E530-8001 | Description: Alignment error When the alignment plate fails to leave the alignment plate front home position sensor position even when the alignment plate front motor was driven for 4 sec. |
| E110-0310 | Description: Laser scanner motor running trouble Trouble in the running of the laser scanner motor for C |
| E749-1001 | Description: Instruction to restart accompanying change in product configuration Error where SDRAM memory as high as 1 GB remains although the controller board version is an old one |
The most common error codes.
| Error | |
|---|---|
| E002-0005 | Description: Insufficient temperature rise of fixing unit When the fixing main thermistor fails to reach 150 deg C within the prescribed period of time after reaching 130 deg C during warm-up |
| E590-8002 | Description: When the puncher cannot detect the punch home position sensor after motor drive has stopped during the initial operation of the punch motor |
| E530-8001 | Description: Alignment error When the alignment plate fails to leave the alignment plate front home position sensor position even when the alignment plate front motor was driven for 4 sec. |
| E110-0310 | Description: Laser scanner motor running trouble Trouble in the running of the laser scanner motor for C |
| E749-1001 | Description: Instruction to restart accompanying change in product configuration Error where SDRAM memory as high as 1 GB remains although the controller board version is an old one |
| E002-0005 | Description: Insufficient temperature rise of fixing unit When the fixing main thermistor fails to reach 150 deg C within the prescribed period of time after reaching 130 deg C during warm-up |
| E590-8002 | Description: When the puncher cannot detect the punch home position sensor after motor drive has stopped during the initial operation of the punch motor |
| E530-8001 | Description: Alignment error When the alignment plate fails to leave the alignment plate front home position sensor position even when the alignment plate front motor was driven for 4 sec. |
| E110-0310 | Description: Laser scanner motor running trouble Trouble in the running of the laser scanner motor for C |
| E749-1001 | Description: Instruction to restart accompanying change in product configuration Error where SDRAM memory as high as 1 GB remains although the controller board version is an old one |
