Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Canon iRC3220N Top Searches

These results are ranked by popularity.

Error
E804-0000Description: The power supply cooling fan is faulty. The DC controller tried to start it up, but the fan has been identified as being at rest for 5 sec continuously.
E606-0002Description: The hard disk is faulty. A reading error is detected when the HD is booted from BOOTROM.
E012-0002Description: The drum ITB motor is faulty. The ITB drum motor fails to rotate after it has rotated. The lock (normal state) signal stops 0.5 sec later.
E402Description: There is a fault in the feeder motor. DADF-K1 The feeder motor (M2) fails to rotate. The feeder motor clock sensor (SR1) is faulty. The feeder motor encoder pulse is not detected within 0.3 sec after the DF feeder motor drive signal has bee
E584-0003Description: There is a fault in feed operation (No. 2). Finisher-N1/Saddle Finisher-N2 The safety area detecting switch (MS3) or the shutter closed switch (MS4) is faulty. The shutter closed switch is OFF when the tray 1/2 is in the OFF position of the

Canon iRC3220N Common Errors

The most common error codes.

Error
E804-0000Description: The power supply cooling fan is faulty. The DC controller tried to start it up, but the fan has been identified as being at rest for 5 sec continuously.
E606-0002Description: The hard disk is faulty. A reading error is detected when the HD is booted from BOOTROM.
E012-0002Description: The drum ITB motor is faulty. The ITB drum motor fails to rotate after it has rotated. The lock (normal state) signal stops 0.5 sec later.
E402Description: There is a fault in the feeder motor. DADF-K1 The feeder motor (M2) fails to rotate. The feeder motor clock sensor (SR1) is faulty. The feeder motor encoder pulse is not detected within 0.3 sec after the DF feeder motor drive signal has bee
E584-0003Description: There is a fault in feed operation (No. 2). Finisher-N1/Saddle Finisher-N2 The safety area detecting switch (MS3) or the shutter closed switch (MS4) is faulty. The shutter closed switch is OFF when the tray 1/2 is in the OFF position of the
E584-0003Description: There is a fault in feed operation (No. 2). Finisher-N1/Saddle Finisher-N2 The safety area detecting switch (MS3) or the shutter closed switch (MS4) is faulty. The shutter closed switch is OFF when the tray 1/2 is in the OFF position of the
E012-0002Description: The drum ITB motor is faulty. The ITB drum motor fails to rotate after it has rotated. The lock (normal state) signal stops 0.5 sec later.
E606-0002Description: The hard disk is faulty. A reading error is detected when the HD is booted from BOOTROM.
E804-0000Description: The power supply cooling fan is faulty. The DC controller tried to start it up, but the fan has been identified as being at rest for 5 sec continuously.
E402Description: There is a fault in the feeder motor. DADF-K1 The feeder motor (M2) fails to rotate. The feeder motor clock sensor (SR1) is faulty. The feeder motor encoder pulse is not detected within 0.3 sec after the DF feeder motor drive signal has bee