Canon iRC3080i Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Canon iRC3080i Top Searches

These results are ranked by popularity.

Error
E611-0000Description: Error in repeat of reboot due to fault of SRAM, etc. SRAM information is broken, job information stored in SRAM cannot be read and reboot is repeated at recovery from power-off
E807-0002Description: Error in fan of process cartridge Error in fan (rear) of process cartridge was detected
E020-0022Description: Error in the developing assembly (toner fault: ATR error) Indicates that the patch level is lower than the lower limit of the target although setting it as the maximum when initializing Cyan ATR.
E240-0001Description: Error in communication of controller There is no response when 3 sec passed since the main controller had sent the pickup request to DC controller during printing.
E530-8001Description: Rear alignment error Finisher-Z1 The HP sensor fails to be ON within 2000ms after the rear adjuster plate starts to move to its HP.

Canon iRC3080i Common Errors

The most common error codes.

Error
E611-0000Description: Error in repeat of reboot due to fault of SRAM, etc. SRAM information is broken, job information stored in SRAM cannot be read and reboot is repeated at recovery from power-off
E807-0002Description: Error in fan of process cartridge Error in fan (rear) of process cartridge was detected
E020-0022Description: Error in the developing assembly (toner fault: ATR error) Indicates that the patch level is lower than the lower limit of the target although setting it as the maximum when initializing Cyan ATR.
E240-0001Description: Error in communication of controller There is no response when 3 sec passed since the main controller had sent the pickup request to DC controller during printing.
E530-8001Description: Rear alignment error Finisher-Z1 The HP sensor fails to be ON within 2000ms after the rear adjuster plate starts to move to its HP.
E593-8002Description: Puncher shift motor error The HP sensor fails to be ON.
E611-0000Description: Error in repeat of reboot due to fault of SRAM, etc. SRAM information is broken, job information stored in SRAM cannot be read and reboot is repeated at recovery from power-off
E537-8002Description: Front alignment error Finisher-Z1 The HP sensor fails to be OFF within 1000ms after the front adjuster plate starts to move from its HP.
E530-8001Description: Rear alignment error Finisher-Z1 The HP sensor fails to be ON within 2000ms after the rear adjuster plate starts to move to its HP.
E020-0022Description: Error in the developing assembly (toner fault: ATR error) Indicates that the patch level is lower than the lower limit of the target although setting it as the maximum when initializing Cyan ATR.