These results are ranked by popularity.
Error | |
---|---|
E351-0000 | Description: Main controller PCB fault Internal error of the main controller PCB |
E012-0005 | Description: Error in activation of motor M After the magenta drum motor speed detection signal became the specified value of the cycle, it exceeds the specified cycle for 2 continuous sec or more. |
E024-0002 | Description: Toner level sensor failure Failure output from the toner level sensor (Cyan). |
E196-0001 | Description: Error in DCON ROM Updating the ROM on the DC controller PCB assembly has been failed. |
E001-0000 | Description: Error in overheating of fixing assembly The status where the detected temperature of the main thermistor is 225 deg C (approx. 0.84V equivalent) or more is detected for 0.5 continuous sec or more. |
The most common error codes.
Error | |
---|---|
E351-0000 | Description: Main controller PCB fault Internal error of the main controller PCB |
E012-0005 | Description: Error in activation of motor M After the magenta drum motor speed detection signal became the specified value of the cycle, it exceeds the specified cycle for 2 continuous sec or more. |
E024-0002 | Description: Toner level sensor failure Failure output from the toner level sensor (Cyan). |
E196-0001 | Description: Error in DCON ROM Updating the ROM on the DC controller PCB assembly has been failed. |
E001-0000 | Description: Error in overheating of fixing assembly The status where the detected temperature of the main thermistor is 225 deg C (approx. 0.84V equivalent) or more is detected for 0.5 continuous sec or more. |
E351-0000 | Description: Main controller PCB fault Internal error of the main controller PCB |
E012-0005 | Description: Error in activation of motor M After the magenta drum motor speed detection signal became the specified value of the cycle, it exceeds the specified cycle for 2 continuous sec or more. |
E024-0002 | Description: Toner level sensor failure Failure output from the toner level sensor (Cyan). |
E196-0001 | Description: Error in DCON ROM Updating the ROM on the DC controller PCB assembly has been failed. |
E001-0000 | Description: Error in overheating of fixing assembly The status where the detected temperature of the main thermistor is 225 deg C (approx. 0.84V equivalent) or more is detected for 0.5 continuous sec or more. |