These results are ranked by popularity.
Error | |
---|---|
E5F6-8004 | Description: There is a saddle butting error. The paper pushing plate leading edge sensor does not go off even when the paper pushing plate motor has been driven for 80 msec. paper pushing plate motor (M8S), paper pushing plate leading edge position sen |
E102-0001 | Description: There is a laser verify error. The machine model ID that has been read from the laser scanner EEPROM is not correct. |
E824-0001 | Description: There is a primary charging cooling fan error. The primary charging cooling fan stop signal has been detected for 5 sec or more even when the primary charging cooling fan is on. |
E020-0002 | Description: There is no toner in the developing assembly; there is an error in the detection of developing toner sensor connection; there is an error in the detection of hopper toner sensor connection. At power-on, the connection of the developing hopp |
E000-0010 | Description: The heater fails to heat. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR) The power has been turned off and then on without resetting the error. |
The most common error codes.
Error | |
---|---|
E5F6-8004 | Description: There is a saddle butting error. The paper pushing plate leading edge sensor does not go off even when the paper pushing plate motor has been driven for 80 msec. paper pushing plate motor (M8S), paper pushing plate leading edge position sen |
E102-0001 | Description: There is a laser verify error. The machine model ID that has been read from the laser scanner EEPROM is not correct. |
E824-0001 | Description: There is a primary charging cooling fan error. The primary charging cooling fan stop signal has been detected for 5 sec or more even when the primary charging cooling fan is on. |
E020-0002 | Description: There is no toner in the developing assembly; there is an error in the detection of developing toner sensor connection; there is an error in the detection of hopper toner sensor connection. At power-on, the connection of the developing hopp |
E000-0010 | Description: The heater fails to heat. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR) The power has been turned off and then on without resetting the error. |
E5F6-8004 | Description: There is a saddle butting error. The paper pushing plate leading edge sensor does not go off even when the paper pushing plate motor has been driven for 80 msec. paper pushing plate motor (M8S), paper pushing plate leading edge position sen |
E102-0001 | Description: There is a laser verify error. The machine model ID that has been read from the laser scanner EEPROM is not correct. |
E824-0001 | Description: There is a primary charging cooling fan error. The primary charging cooling fan stop signal has been detected for 5 sec or more even when the primary charging cooling fan is on. |
E020-0002 | Description: There is no toner in the developing assembly; there is an error in the detection of developing toner sensor connection; there is an error in the detection of hopper toner sensor connection. At power-on, the connection of the developing hopp |
E000-0010 | Description: The heater fails to heat. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR) The power has been turned off and then on without resetting the error. |