Canon iR5055 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Canon iR5055 Top Searches

These results are ranked by popularity.

Error
E020-0000Description: There is no toner in the developing assembly; there is an error in the detection of developing toner sensor connection; there is an error in the detection of hopper toner sensor connection. The presence of toner is detected inside the sub h
E530-8001Description: There is a front alignment error. (finisher) The home position sensor does not go off even when the front alignment motor has rotated for a specific period of time.
E593-8002Description: There is a punch shift motor error. (punch unit) In the absence of light, the incoming light voltage HP sensor does not go on.
E719-0001Description: There is a fault in the coin vendor. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR) An error has occurred at time of coin vendor start-up. The coin vendor was connected before power-off, but is not conne
E196-2abbDescription: The EEPROM is faulty. The ID in EEPROM that has been read and the ID in ROM are compared. An error will be identified if they do not match. (a: chip No. 0 through 5; bb: chip faulty address)

Canon iR5055 Common Errors

The most common error codes.

Error
E020-0000Description: There is no toner in the developing assembly; there is an error in the detection of developing toner sensor connection; there is an error in the detection of hopper toner sensor connection. The presence of toner is detected inside the sub h
E530-8001Description: There is a front alignment error. (finisher) The home position sensor does not go off even when the front alignment motor has rotated for a specific period of time.
E593-8002Description: There is a punch shift motor error. (punch unit) In the absence of light, the incoming light voltage HP sensor does not go on.
E719-0001Description: There is a fault in the coin vendor. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR) An error has occurred at time of coin vendor start-up. The coin vendor was connected before power-off, but is not conne
E196-2abbDescription: The EEPROM is faulty. The ID in EEPROM that has been read and the ID in ROM are compared. An error will be identified if they do not match. (a: chip No. 0 through 5; bb: chip faulty address)
E719-0001Description: There is a fault in the coin vendor. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR) An error has occurred at time of coin vendor start-up. The coin vendor was connected before power-off, but is not conne
E530-8001Description: There is a front alignment error. (finisher) The home position sensor does not go off even when the front alignment motor has rotated for a specific period of time.
E593-8002Description: There is a punch shift motor error. (punch unit) In the absence of light, the incoming light voltage HP sensor does not go on.
E020-0000Description: There is no toner in the developing assembly; there is an error in the detection of developing toner sensor connection; there is an error in the detection of hopper toner sensor connection. The presence of toner is detected inside the sub h
E804-0001Description: There is a DC power supply fan error/there is an IH power supply cooling fan error. The IH power supply cooling fan stop signal has been detected for 5 sec or more even when the IH power supply cooling fan is on.