These results are ranked by popularity.
Error | |
---|---|
E602-0004 | Description: The wiring is faulty (short circuit, open circuit). The hard disk drive is faulty. The main controller PCB is faulty. A an error is found in the read/write address for the hard disk. |
E590-0001 | Description: The punch home position sensor (PI3P) is faulty. The punch motor (M1P) is faulty. The punch driver PCB is faulty. The puncher does not leave home position when the punch motor has been driven for 200 msecs. |
E248-0002 | Description: The EEPROM on the reader controller PCB is faulty. The reader controller PCB is faulty. When data is written into EEPROM, the data written and the data read do not match. |
E503-0002 | Description: The saddle stitcher controller PCB is faulty. The finisher controller PCB is faulty. The communication between the saddle stitcher controller PCB and the finisher controller PCB has been interrupted. |
E013-0000 | Description: The waste toner feedscrew is faulty. The water toner clock sensor (MSW2) is faulty. The DC controller PCB is faulty. The rotation of the waste toner feedscrew goes out of order, and the switch (MSW2) is pressed multiple times during a speci |
The most common error codes.
Error | |
---|---|
E602-0004 | Description: The wiring is faulty (short circuit, open circuit). The hard disk drive is faulty. The main controller PCB is faulty. A an error is found in the read/write address for the hard disk. |
E590-0001 | Description: The punch home position sensor (PI3P) is faulty. The punch motor (M1P) is faulty. The punch driver PCB is faulty. The puncher does not leave home position when the punch motor has been driven for 200 msecs. |
E248-0002 | Description: The EEPROM on the reader controller PCB is faulty. The reader controller PCB is faulty. When data is written into EEPROM, the data written and the data read do not match. |
E503-0002 | Description: The saddle stitcher controller PCB is faulty. The finisher controller PCB is faulty. The communication between the saddle stitcher controller PCB and the finisher controller PCB has been interrupted. |
E013-0000 | Description: The waste toner feedscrew is faulty. The water toner clock sensor (MSW2) is faulty. The DC controller PCB is faulty. The rotation of the waste toner feedscrew goes out of order, and the switch (MSW2) is pressed multiple times during a speci |
E602-0004 | Description: The wiring is faulty (short circuit, open circuit). The hard disk drive is faulty. The main controller PCB is faulty. A an error is found in the read/write address for the hard disk. |
E590-0001 | Description: The punch home position sensor (PI3P) is faulty. The punch motor (M1P) is faulty. The punch driver PCB is faulty. The puncher does not leave home position when the punch motor has been driven for 200 msecs. |
E248-0002 | Description: The EEPROM on the reader controller PCB is faulty. The reader controller PCB is faulty. When data is written into EEPROM, the data written and the data read do not match. |
E503-0002 | Description: The saddle stitcher controller PCB is faulty. The finisher controller PCB is faulty. The communication between the saddle stitcher controller PCB and the finisher controller PCB has been interrupted. |
E013-0000 | Description: The waste toner feedscrew is faulty. The water toner clock sensor (MSW2) is faulty. The DC controller PCB is faulty. The rotation of the waste toner feedscrew goes out of order, and the switch (MSW2) is pressed multiple times during a speci |