Canon iR5000D Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Canon iR5000D Top Searches

These results are ranked by popularity.

Error
E248-0002Description: The EEPROM on the reader controller PCB is faulty. The reader controller PCB is faulty. When data is written into EEPROM, the data written and the data read do not match.
E602-0004Description: The wiring is faulty (short circuit, open circuit). The hard disk drive is faulty. The main controller PCB is faulty. A an error is found in the read/write address for the hard disk.
E590-0001Description: The punch home position sensor (PI3P) is faulty. The punch motor (M1P) is faulty. The punch driver PCB is faulty. The puncher does not leave home position when the punch motor has been driven for 200 msecs.
E713-0000Description: The connector is not connected properly. The finisher accessories power supply PCB is faulty. The finisher controller PCB is faulty. The DC controller PCB is faulty. The communications IC (IPC) on the finisher controller has gone out of ord
E5F3-0002Description: The alignment home position sensor (PI5S) is faulty. The alignment motor (M5S) is faulty. The saddle stitcher controller PCB is faulty. The alignment plate home position sensor does not turn off when the alignment motor has been driven for

Canon iR5000D Common Errors

The most common error codes.

Error
E248-0002Description: The EEPROM on the reader controller PCB is faulty. The reader controller PCB is faulty. When data is written into EEPROM, the data written and the data read do not match.
E602-0004Description: The wiring is faulty (short circuit, open circuit). The hard disk drive is faulty. The main controller PCB is faulty. A an error is found in the read/write address for the hard disk.
E590-0001Description: The punch home position sensor (PI3P) is faulty. The punch motor (M1P) is faulty. The punch driver PCB is faulty. The puncher does not leave home position when the punch motor has been driven for 200 msecs.
E713-0000Description: The connector is not connected properly. The finisher accessories power supply PCB is faulty. The finisher controller PCB is faulty. The DC controller PCB is faulty. The communications IC (IPC) on the finisher controller has gone out of ord
E5F3-0002Description: The alignment home position sensor (PI5S) is faulty. The alignment motor (M5S) is faulty. The saddle stitcher controller PCB is faulty. The alignment plate home position sensor does not turn off when the alignment motor has been driven for
E248-0002Description: The EEPROM on the reader controller PCB is faulty. The reader controller PCB is faulty. When data is written into EEPROM, the data written and the data read do not match.
E602-0004Description: The wiring is faulty (short circuit, open circuit). The hard disk drive is faulty. The main controller PCB is faulty. A an error is found in the read/write address for the hard disk.
E590-0001Description: The punch home position sensor (PI3P) is faulty. The punch motor (M1P) is faulty. The punch driver PCB is faulty. The puncher does not leave home position when the punch motor has been driven for 200 msecs.
E713-0000Description: The connector is not connected properly. The finisher accessories power supply PCB is faulty. The finisher controller PCB is faulty. The DC controller PCB is faulty. The communications IC (IPC) on the finisher controller has gone out of ord
E5F3-0002Description: The alignment home position sensor (PI5S) is faulty. The alignment motor (M5S) is faulty. The saddle stitcher controller PCB is faulty. The alignment plate home position sensor does not turn off when the alignment motor has been driven for