These results are ranked by popularity.
Error | |
---|---|
E592-0001 | Description: Paper trailing edge sensor/ horizontal sensor error Error in light-receiving voltage when light is emitted (trailing edge sensor) |
E531-8002 | Description: Stapler error (Finisher-S1) The home position sensor does not go off within 500 msec after the stapler motor has been started. |
E248-0002 | Description: The backup memory is faulty. An error has occurred during a write operation. |
E719-0002 | Description: There is a coin vendor error. While the coin vendor is in operation, an IPC error has occurred, IPC has developed an open circuit, or an error preventing recovery of IPC communication has occurred. An open circuit has been detected in the li |
E003-0000 | Description: The fixing temperature is too low after a standby state. While regular temperature control is under way, the reading of the main thermistor is less than 140 deg C continuously for 400 msec or more. |
The most common error codes.
Error | |
---|---|
E592-0001 | Description: Paper trailing edge sensor/ horizontal sensor error Error in light-receiving voltage when light is emitted (trailing edge sensor) |
E531-8002 | Description: Stapler error (Finisher-S1) The home position sensor does not go off within 500 msec after the stapler motor has been started. |
E248-0002 | Description: The backup memory is faulty. An error has occurred during a write operation. |
E719-0002 | Description: There is a coin vendor error. While the coin vendor is in operation, an IPC error has occurred, IPC has developed an open circuit, or an error preventing recovery of IPC communication has occurred. An open circuit has been detected in the li |
E003-0000 | Description: The fixing temperature is too low after a standby state. While regular temperature control is under way, the reading of the main thermistor is less than 140 deg C continuously for 400 msec or more. |
E592-0001 | Description: Paper trailing edge sensor/ horizontal sensor error Error in light-receiving voltage when light is emitted (trailing edge sensor) |
E531-8002 | Description: Stapler error (Finisher-S1) The home position sensor does not go off within 500 msec after the stapler motor has been started. |
E248-0002 | Description: The backup memory is faulty. An error has occurred during a write operation. |
E719-0002 | Description: There is a coin vendor error. While the coin vendor is in operation, an IPC error has occurred, IPC has developed an open circuit, or an error preventing recovery of IPC communication has occurred. An open circuit has been detected in the li |
E003-0000 | Description: The fixing temperature is too low after a standby state. While regular temperature control is under way, the reading of the main thermistor is less than 140 deg C continuously for 400 msec or more. |