These results are ranked by popularity.
| Error | |
|---|---|
| E261-0000 | Description: The zero-cross signal is faulty. When the relay is on, the zero-cross signal is not detected for 500 msec or more. |
| E719-0011 | Description: There is a coin vendor error. An error has occurred at new card reader startup. The new card reader is not connected when the power is turned off, although it was connected when the power was turned off. |
| E010-0001 | Description: The rotation of the main motor is faulty. Detection is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec. |
| E5F8-0003 | Description: Saddle connector error The connector of the paper butting plate leading edge sensor has been identified as being disconnected. Connector of paper butting plate leading edge sensor (PI15S) |
| E592-0003 | Description: Power trailing edge sensor/ registration sensor Error in light-receiving voltage when light is emitted (horizontal registration sensor 1) |
The most common error codes.
| Error | |
|---|---|
| E261-0000 | Description: The zero-cross signal is faulty. When the relay is on, the zero-cross signal is not detected for 500 msec or more. |
| E719-0011 | Description: There is a coin vendor error. An error has occurred at new card reader startup. The new card reader is not connected when the power is turned off, although it was connected when the power was turned off. |
| E010-0001 | Description: The rotation of the main motor is faulty. Detection is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec. |
| E5F8-0003 | Description: Saddle connector error The connector of the paper butting plate leading edge sensor has been identified as being disconnected. Connector of paper butting plate leading edge sensor (PI15S) |
| E592-0003 | Description: Power trailing edge sensor/ registration sensor Error in light-receiving voltage when light is emitted (horizontal registration sensor 1) |
| E261-0000 | Description: The zero-cross signal is faulty. When the relay is on, the zero-cross signal is not detected for 500 msec or more. |
| E719-0011 | Description: There is a coin vendor error. An error has occurred at new card reader startup. The new card reader is not connected when the power is turned off, although it was connected when the power was turned off. |
| E010-0001 | Description: The rotation of the main motor is faulty. Detection is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec. |
| E5F8-0003 | Description: Saddle connector error The connector of the paper butting plate leading edge sensor has been identified as being disconnected. Connector of paper butting plate leading edge sensor (PI15S) |
| E592-0003 | Description: Power trailing edge sensor/ registration sensor Error in light-receiving voltage when light is emitted (horizontal registration sensor 1) |
