Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Canon iR2200i Top Searches

These results are ranked by popularity.

Error
E711-0003Description: Data is written to the error register of the communication IC (IPC) on the main controller PCB four times or more within 2 sec
E805-0002Description: The clock signal is absent for 5 sec or more after the fan drive signal has been generated. The detail codes of the fans in question are as follows: fixing fan (FM2)
E505-0001Description: When the main power is turned on, the checksum of the finisher controller PCB has a fault
E100-0003Description: While the laser is ON, the horizontal sync signal cycle is outside a specific range 20 times or more
E737-0000Description: During self diagnosis at power-on, the DRAM check finds a fault in the main controller PCB

Canon iR2200i Common Errors

The most common error codes.

Error
E711-0003Description: Data is written to the error register of the communication IC (IPC) on the main controller PCB four times or more within 2 sec
E805-0002Description: The clock signal is absent for 5 sec or more after the fan drive signal has been generated. The detail codes of the fans in question are as follows: fixing fan (FM2)
E505-0001Description: When the main power is turned on, the checksum of the finisher controller PCB has a fault
E100-0003Description: While the laser is ON, the horizontal sync signal cycle is outside a specific range 20 times or more
E737-0000Description: During self diagnosis at power-on, the DRAM check finds a fault in the main controller PCB
E711-0003Description: Data is written to the error register of the communication IC (IPC) on the main controller PCB four times or more within 2 sec
E805-0002Description: The clock signal is absent for 5 sec or more after the fan drive signal has been generated. The detail codes of the fans in question are as follows: fixing fan (FM2)
E505-0001Description: When the main power is turned on, the checksum of the finisher controller PCB has a fault
E100-0003Description: While the laser is ON, the horizontal sync signal cycle is outside a specific range 20 times or more
E737-0000Description: During self diagnosis at power-on, the DRAM check finds a fault in the main controller PCB