These results are ranked by popularity.
Error | |
---|---|
E261-0000 | Description: Zero-cross signal error If failed to detect zero-cross signal cycle of the power supply when initializing. When the input of the zero-signal failed continuously for three seconds while controlling the temperature adjustment. |
E739-0000 | Description: Erroneous communication between controller and network board The installed network board is incompatible. |
E542-0002 | Description: - Optional tray motor or finisher controller PCB failure - Optional tray HP sensor failure - Optional tray clock sensor failure - Optional tray shift motor load failure Cannot move (to the pickup position) within the specified time. |
E003-0001 | Description: Abnormally low temperature (detected by sub thermistor) After the temperature detected by the sub thermistor has reached the specified value, it does not reach the specified value during initial rotation. |
E500-0001 | Description: Finisher communication error Data communication could not be performed normally. It has been retried three times in vain. |
The most common error codes.
Error | |
---|---|
E261-0000 | Description: Zero-cross signal error If failed to detect zero-cross signal cycle of the power supply when initializing. When the input of the zero-signal failed continuously for three seconds while controlling the temperature adjustment. |
E739-0000 | Description: Erroneous communication between controller and network board The installed network board is incompatible. |
E542-0002 | Description: - Optional tray motor or finisher controller PCB failure - Optional tray HP sensor failure - Optional tray clock sensor failure - Optional tray shift motor load failure Cannot move (to the pickup position) within the specified time. |
E003-0001 | Description: Abnormally low temperature (detected by sub thermistor) After the temperature detected by the sub thermistor has reached the specified value, it does not reach the specified value during initial rotation. |
E500-0001 | Description: Finisher communication error Data communication could not be performed normally. It has been retried three times in vain. |
E261-0000 | Description: Zero-cross signal error If failed to detect zero-cross signal cycle of the power supply when initializing. When the input of the zero-signal failed continuously for three seconds while controlling the temperature adjustment. |
E739-0000 | Description: Erroneous communication between controller and network board The installed network board is incompatible. |
E542-0002 | Description: - Optional tray motor or finisher controller PCB failure - Optional tray HP sensor failure - Optional tray clock sensor failure - Optional tray shift motor load failure Cannot move (to the pickup position) within the specified time. |
E003-0001 | Description: Abnormally low temperature (detected by sub thermistor) After the temperature detected by the sub thermistor has reached the specified value, it does not reach the specified value during initial rotation. |
E500-0001 | Description: Finisher communication error Data communication could not be performed normally. It has been retried three times in vain. |