Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Canon iR2000 Top Searches

These results are ranked by popularity.

Error
E000Description: The main thermistor reading does not reach 40C 14 sec after the fixing heater goes ON (fixing low temperature error)
E537Description: The front aligning plate does not reach home position when the front aligning motor (M3) is driven for a specific time. The front aligning plate does not leave home position when the front alignment motor (M3) is driven for a specific time.
E001Description: The main thermistor reading reaches 220°C or higher (fixing high temperature error)
E551Description: The delivery fan rotation signal (FNALCOK) does not arrive within 1 sec when the heat discharge fan drive signal (FANON) is sent.
E002Description: A start-up fault is detected under any of the following conditions of the main thermistor (start-up detection fault): after exceeding 40°C, it fails to reach 60°C within 10 sec. after exceeding 60°C, it fails to reach 80°C within 10 sec.

Canon iR2000 Common Errors

The most common error codes.

Error
E000Description: The main thermistor reading does not reach 40C 14 sec after the fixing heater goes ON (fixing low temperature error)
E537Description: The front aligning plate does not reach home position when the front aligning motor (M3) is driven for a specific time. The front aligning plate does not leave home position when the front alignment motor (M3) is driven for a specific time.
E001Description: The main thermistor reading reaches 220°C or higher (fixing high temperature error)
E551Description: The delivery fan rotation signal (FNALCOK) does not arrive within 1 sec when the heat discharge fan drive signal (FANON) is sent.
E002Description: A start-up fault is detected under any of the following conditions of the main thermistor (start-up detection fault): after exceeding 40°C, it fails to reach 60°C within 10 sec. after exceeding 60°C, it fails to reach 80°C within 10 sec.
E000Description: The main thermistor reading does not reach 40C 14 sec after the fixing heater goes ON (fixing low temperature error)
E537Description: The front aligning plate does not reach home position when the front aligning motor (M3) is driven for a specific time. The front aligning plate does not leave home position when the front alignment motor (M3) is driven for a specific time.
E001Description: The main thermistor reading reaches 220°C or higher (fixing high temperature error)
E551Description: The delivery fan rotation signal (FNALCOK) does not arrive within 1 sec when the heat discharge fan drive signal (FANON) is sent.
E002Description: A start-up fault is detected under any of the following conditions of the main thermistor (start-up detection fault): after exceeding 40°C, it fails to reach 60°C within 10 sec. after exceeding 60°C, it fails to reach 80°C within 10 sec.