Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Canon iR1740i Top Searches

These results are ranked by popularity.

Error
E350-0001Description: System error
E001-0002Description: Detection of overheating of Fixing Assembly The Sub Thermistor detected 295 deg C or higher for 200msec or longer on end.
E820-0002Description: Developing Cooling Fan (Rear) (FM8) error A lock signal was detected for 5 seconds while the Developing Cooling Fan (Rear) (FM8) was being stopped. *The same status was detected again after executing an error retry
E020-0000Description: Detection of toner clog between the Hopper and the Developing Assembly When the Developing Assembly Toner Sensor (TS2) detected "toner absent" and the Hopper Toner Sensor (TS1) detected "toner-present", the Hopper Motor (M6) was rotated 194
E531-8001Description: Staple Motor (M9) error The Stapler failed to move from the Staple HP Sensor (S11) within the staple execution time (0.45sec).

Canon iR1740i Common Errors

The most common error codes.

Error
E350-0001Description: System error
E001-0002Description: Detection of overheating of Fixing Assembly The Sub Thermistor detected 295 deg C or higher for 200msec or longer on end.
E820-0002Description: Developing Cooling Fan (Rear) (FM8) error A lock signal was detected for 5 seconds while the Developing Cooling Fan (Rear) (FM8) was being stopped. *The same status was detected again after executing an error retry
E020-0000Description: Detection of toner clog between the Hopper and the Developing Assembly When the Developing Assembly Toner Sensor (TS2) detected "toner absent" and the Hopper Toner Sensor (TS1) detected "toner-present", the Hopper Motor (M6) was rotated 194
E531-8001Description: Staple Motor (M9) error The Stapler failed to move from the Staple HP Sensor (S11) within the staple execution time (0.45sec).
E350-0001Description: System error
E001-0002Description: Detection of overheating of Fixing Assembly The Sub Thermistor detected 295 deg C or higher for 200msec or longer on end.
E820-0002Description: Developing Cooling Fan (Rear) (FM8) error A lock signal was detected for 5 seconds while the Developing Cooling Fan (Rear) (FM8) was being stopped. *The same status was detected again after executing an error retry
E020-0000Description: Detection of toner clog between the Hopper and the Developing Assembly When the Developing Assembly Toner Sensor (TS2) detected "toner absent" and the Hopper Toner Sensor (TS1) detected "toner-present", the Hopper Motor (M6) was rotated 194
E531-8001Description: Staple Motor (M9) error The Stapler failed to move from the Staple HP Sensor (S11) within the staple execution time (0.45sec).