Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Canon iR1600 Top Searches

These results are ranked by popularity.

Error
E531Description: The stapler does not leave the stapling home position sensor (S13) within 0.5 sec after the stapler motor (M6) is rotated CW. The stapler does to return to the home position sensor (S13) within 0.5 sec after the stapler motor (M6) is driven
E000Description: The main thermistor reading does not reach 40C 14 sec after the fixing heater goes ON (fixing low temperature error)
E537Description: The front aligning plate does not reach home position when the front aligning motor (M3) is driven for a specific time. The front aligning plate does not leave home position when the front alignment motor (M3) is driven for a specific time.
E001Description: The main thermistor reading reaches 220°C or higher (fixing high temperature error)
E551Description: The delivery fan rotation signal (FNALCOK) does not arrive within 1 sec when the heat discharge fan drive signal (FANON) is sent.

Canon iR1600 Common Errors

The most common error codes.

Error
E531Description: The stapler does not leave the stapling home position sensor (S13) within 0.5 sec after the stapler motor (M6) is rotated CW. The stapler does to return to the home position sensor (S13) within 0.5 sec after the stapler motor (M6) is driven
E000Description: The main thermistor reading does not reach 40C 14 sec after the fixing heater goes ON (fixing low temperature error)
E537Description: The front aligning plate does not reach home position when the front aligning motor (M3) is driven for a specific time. The front aligning plate does not leave home position when the front alignment motor (M3) is driven for a specific time.
E001Description: The main thermistor reading reaches 220°C or higher (fixing high temperature error)
E551Description: The delivery fan rotation signal (FNALCOK) does not arrive within 1 sec when the heat discharge fan drive signal (FANON) is sent.
E531Description: The stapler does not leave the stapling home position sensor (S13) within 0.5 sec after the stapler motor (M6) is rotated CW. The stapler does to return to the home position sensor (S13) within 0.5 sec after the stapler motor (M6) is driven
E000Description: The main thermistor reading does not reach 40C 14 sec after the fixing heater goes ON (fixing low temperature error)
E537Description: The front aligning plate does not reach home position when the front aligning motor (M3) is driven for a specific time. The front aligning plate does not leave home position when the front alignment motor (M3) is driven for a specific time.
E001Description: The main thermistor reading reaches 220°C or higher (fixing high temperature error)
E551Description: The delivery fan rotation signal (FNALCOK) does not arrive within 1 sec when the heat discharge fan drive signal (FANON) is sent.