Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Canon iR1370 Top Searches

These results are ranked by popularity.

Error
E002-001Description: After power-on/start of printing, the reading of the main thermistor does not reach the target value -15°C/11°F or higher within 75 sec. About 10 sec or later after the heater is supplied with power, the sub thermistor detects less than 75°C
E003Description: During printing, the main thermistor detects less than 120°C/248°F for 1 sec or more continuously.
E100Description: About 1.5 sec after the scanner drive signal output, the BDI* signal is not detected 3 times or more for 1.0 sec. While the laser is ON, the BD signal cycle is not as indicated for 0.5 or more continuously.
E110Description: The scanner fails to reach the target speed of rotation 10 sec after the laser scanner motor reaches constant speed state.
E805Description: While the fan is rotating, fan lock state is detected for 10 sec or more continuously.

Canon iR1370 Common Errors

The most common error codes.

Error
E002-001Description: After power-on/start of printing, the reading of the main thermistor does not reach the target value -15°C/11°F or higher within 75 sec. About 10 sec or later after the heater is supplied with power, the sub thermistor detects less than 75°C
E003Description: During printing, the main thermistor detects less than 120°C/248°F for 1 sec or more continuously.
E100Description: About 1.5 sec after the scanner drive signal output, the BDI* signal is not detected 3 times or more for 1.0 sec. While the laser is ON, the BD signal cycle is not as indicated for 0.5 or more continuously.
E110Description: The scanner fails to reach the target speed of rotation 10 sec after the laser scanner motor reaches constant speed state.
E805Description: While the fan is rotating, fan lock state is detected for 10 sec or more continuously.
E002-001Description: After power-on/start of printing, the reading of the main thermistor does not reach the target value -15°C/11°F or higher within 75 sec. About 10 sec or later after the heater is supplied with power, the sub thermistor detects less than 75°C
E003Description: During printing, the main thermistor detects less than 120°C/248°F for 1 sec or more continuously.
E100Description: About 1.5 sec after the scanner drive signal output, the BDI* signal is not detected 3 times or more for 1.0 sec. While the laser is ON, the BD signal cycle is not as indicated for 0.5 or more continuously.
E110Description: The scanner fails to reach the target speed of rotation 10 sec after the laser scanner motor reaches constant speed state.
E805Description: While the fan is rotating, fan lock state is detected for 10 sec or more continuously.