These results are ranked by popularity.
Error | |
---|---|
050B | Description: When the center thermistor of the fuser unit was lower than the idle temperature, the side thermistor detected a temperature higher than the specified temperature. |
7302 | Description: When printing from the paper tray 1, the registration front sensor does not detect paper pass within the specified time after the T1 paper feed sensor detected paper pass. |
9006 | Description: When printing from the paper tray 5, the size of paper set in the paper tray 5 does not match the size specified by the driver. |
9304 | Description: When printing from paper tray 3, the T3(LT or TT) paper empty sensor detected that there was no paper set in paper tray 3. |
8501 | Description: When printing from paper tray 1, 2, 3, 4 or 5, the T1 paper feed sensor detected open paper tray 1 (before registering printing data to engine). |
The most common error codes.
Error | |
---|---|
050B | Description: When the center thermistor of the fuser unit was lower than the idle temperature, the side thermistor detected a temperature higher than the specified temperature. |
7302 | Description: When printing from the paper tray 1, the registration front sensor does not detect paper pass within the specified time after the T1 paper feed sensor detected paper pass. |
9006 | Description: When printing from the paper tray 5, the size of paper set in the paper tray 5 does not match the size specified by the driver. |
9304 | Description: When printing from paper tray 3, the T3(LT or TT) paper empty sensor detected that there was no paper set in paper tray 3. |
8501 | Description: When printing from paper tray 1, 2, 3, 4 or 5, the T1 paper feed sensor detected open paper tray 1 (before registering printing data to engine). |
050B | Description: When the center thermistor of the fuser unit was lower than the idle temperature, the side thermistor detected a temperature higher than the specified temperature. |
7302 | Description: When printing from the paper tray 1, the registration front sensor does not detect paper pass within the specified time after the T1 paper feed sensor detected paper pass. |
9006 | Description: When printing from the paper tray 5, the size of paper set in the paper tray 5 does not match the size specified by the driver. |
9304 | Description: When printing from paper tray 3, the T3(LT or TT) paper empty sensor detected that there was no paper set in paper tray 3. |
8501 | Description: When printing from paper tray 1, 2, 3, 4 or 5, the T1 paper feed sensor detected open paper tray 1 (before registering printing data to engine). |