Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Brother DCP-L2550DN Top Searches

These results are ranked by popularity.

Error
0201Description: Cannot detect the synchronized signal of the paper feed motor. The speed of the paper feed motor does not stabilize within the specified time.
9001Description: The size of paper loaded in the MP tray and the one specified from the driver are not same when paper is fed from the MP tray.
4F01Description: The new toner sensor of the toner cartridge could not detect a new cartridge properly.
6001Description: The front cover sensor detected that the front cover was open.
0508Description: Temperature of the end part didn’t rise by 1 °C when the fuser unit heater was turned ON.

Brother DCP-L2550DN Common Errors

The most common error codes.

Error
0201Description: Cannot detect the synchronized signal of the paper feed motor. The speed of the paper feed motor does not stabilize within the specified time.
9001Description: The size of paper loaded in the MP tray and the one specified from the driver are not same when paper is fed from the MP tray.
4F01Description: The new toner sensor of the toner cartridge could not detect a new cartridge properly.
6001Description: The front cover sensor detected that the front cover was open.
0508Description: Temperature of the end part didn’t rise by 1 °C when the fuser unit heater was turned ON.
0201Description: Cannot detect the synchronized signal of the paper feed motor. The speed of the paper feed motor does not stabilize within the specified time.
9001Description: The size of paper loaded in the MP tray and the one specified from the driver are not same when paper is fed from the MP tray.
4F01Description: The new toner sensor of the toner cartridge could not detect a new cartridge properly.
6001Description: The front cover sensor detected that the front cover was open.
0508Description: Temperature of the end part didn’t rise by 1 °C when the fuser unit heater was turned ON.