These results are ranked by popularity.
| Error | |
|---|---|
| F93 | Description: Finisher Jog Motor Failure An error was detected in either the Front or Rear Alignment Motor. |
| U34 | Description: Unsupported Duplex Unit ROM The installed Duplex Unit does not contain the correct firmware. |
| 920 ... 920 | Description: Failure in the [C][M][Y][K] Imaging Unit Drum or Motor The Drum Phase Sensor integrated on the Imaging Unit Sensor Board indicates an error in one of the Imaging Units. Code 920: The Yellow Imaging Unit drum is not rotating. Code 921: The Ma |
| D1 | Description: Jam at Door D Open Door D to Clear Media reached Duplex Reverse Sensor, but did not leave the Duplex Unit on time. This error represents a misfeed jam inside the Duplex Unit. |
| T1, T2 | Description: Fuser Failure The Fuser temperature regulation has failed. Code T1: Fuser Upper Failure Code T2: Fuser Lower Failure |
The most common error codes.
| Error | |
|---|---|
| F93 | Description: Finisher Jog Motor Failure An error was detected in either the Front or Rear Alignment Motor. |
| U34 | Description: Unsupported Duplex Unit ROM The installed Duplex Unit does not contain the correct firmware. |
| 920 ... 920 | Description: Failure in the [C][M][Y][K] Imaging Unit Drum or Motor The Drum Phase Sensor integrated on the Imaging Unit Sensor Board indicates an error in one of the Imaging Units. Code 920: The Yellow Imaging Unit drum is not rotating. Code 921: The Ma |
| D1 | Description: Jam at Door D Open Door D to Clear Media reached Duplex Reverse Sensor, but did not leave the Duplex Unit on time. This error represents a misfeed jam inside the Duplex Unit. |
| T1, T2 | Description: Fuser Failure The Fuser temperature regulation has failed. Code T1: Fuser Upper Failure Code T2: Fuser Lower Failure |
| F93 | Description: Finisher Jog Motor Failure An error was detected in either the Front or Rear Alignment Motor. |
| U34 | Description: Unsupported Duplex Unit ROM The installed Duplex Unit does not contain the correct firmware. |
| 920 ... 920 | Description: Failure in the [C][M][Y][K] Imaging Unit Drum or Motor The Drum Phase Sensor integrated on the Imaging Unit Sensor Board indicates an error in one of the Imaging Units. Code 920: The Yellow Imaging Unit drum is not rotating. Code 921: The Ma |
| D1 | Description: Jam at Door D Open Door D to Clear Media reached Duplex Reverse Sensor, but did not leave the Duplex Unit on time. This error represents a misfeed jam inside the Duplex Unit. |
| T1, T2 | Description: Fuser Failure The Fuser temperature regulation has failed. Code T1: Fuser Upper Failure Code T2: Fuser Lower Failure |
