Toshiba e-Studio 456S Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Toshiba e-Studio 456S Top Searches

These results are ranked by popularity.

Error
EAE0Description: Receiving time time-out jam: The printing has been interrupted because of the communication error between the equipment and finisher when the paper is transported from the equipment to the finisher.
F103Description: HDD transfer time-out: Reading/writing cannot be performed in the specified period of time.
E920Description: Stop jam at the bridge unit transport sensor-1: The trailing edge of the paper does not pass the bridge unit transport sensor-1 after its leading edge has reached the sensor.
CC51Description: Sideways adjustment motor (M2) abnormality: Sideways adjustment motor is not rotating or puncher is not shifting normally. [MJ-1101/MJ-1106 (when MJ-6103 is installed)]
F901_1Description: Engine speed error: The speed information of the LGC board is damaged.

Toshiba e-Studio 456S Common Errors

The most common error codes.

Error
EAE0Description: Receiving time time-out jam: The printing has been interrupted because of the communication error between the equipment and finisher when the paper is transported from the equipment to the finisher.
F103Description: HDD transfer time-out: Reading/writing cannot be performed in the specified period of time.
E920Description: Stop jam at the bridge unit transport sensor-1: The trailing edge of the paper does not pass the bridge unit transport sensor-1 after its leading edge has reached the sensor.
CC51Description: Sideways adjustment motor (M2) abnormality: Sideways adjustment motor is not rotating or puncher is not shifting normally. [MJ-1101/MJ-1106 (when MJ-6103 is installed)]
F901_1Description: Engine speed error: The speed information of the LGC board is damaged.
E920Description: Stop jam at the bridge unit transport sensor-1: The trailing edge of the paper does not pass the bridge unit transport sensor-1 after its leading edge has reached the sensor.
F103Description: HDD transfer time-out: Reading/writing cannot be performed in the specified period of time.
E220Description: Lower drawer transport jam (Paper not reaching the 1st transport sensor): The paper does not reach the 1st transport sensor after it has passed the lower drawer feed sensor.
CC51Description: Sideways adjustment motor (M2) abnormality: Sideways adjustment motor is not rotating or puncher is not shifting normally. [MJ-1101/MJ-1106 (when MJ-6103 is installed)]
F901_1Description: Engine speed error: The speed information of the LGC board is damaged.