These results are ranked by popularity.
| Error | |
|---|---|
| U7-00 | Description: RIC communication trouble Communication error with RIC (By PPC communication standards) An error in the communication line test after turning on the power or canceling the simulation |
| H4-02 | Description: Fusing section low temperature trouble (HL3) The set temperature is not reached within the specified time (normally 3 min or 5 min in the curl prevention mode) after turning on the power relay. When the heater lamp is not turned off in 4 min |
| F2-02 | Description: Toner supply abnormality Toner remains in the toner bottle when undertoner is detected by the toner concentration sensor in the developing unit. |
| E7-67 | Description: Incompatibility check (70ppm) (MFP controller detection) An error is detected in the internal incompatibility check in the MFP control PWB. |
| F3-12 | Description: Machine tray 1 lift-up trouble PED does not turn on within the specified time. LUD does not turn on within the specified time. The trouble occurs 3 times continuously that the upper limit sensor does not turn on by lift-up operation for 21se |
The most common error codes.
| Error | |
|---|---|
| U7-00 | Description: RIC communication trouble Communication error with RIC (By PPC communication standards) An error in the communication line test after turning on the power or canceling the simulation |
| H4-02 | Description: Fusing section low temperature trouble (HL3) The set temperature is not reached within the specified time (normally 3 min or 5 min in the curl prevention mode) after turning on the power relay. When the heater lamp is not turned off in 4 min |
| F2-02 | Description: Toner supply abnormality Toner remains in the toner bottle when undertoner is detected by the toner concentration sensor in the developing unit. |
| E7-67 | Description: Incompatibility check (70ppm) (MFP controller detection) An error is detected in the internal incompatibility check in the MFP control PWB. |
| F3-12 | Description: Machine tray 1 lift-up trouble PED does not turn on within the specified time. LUD does not turn on within the specified time. The trouble occurs 3 times continuously that the upper limit sensor does not turn on by lift-up operation for 21se |
| U7-00 | Description: RIC communication trouble Communication error with RIC (By PPC communication standards) An error in the communication line test after turning on the power or canceling the simulation |
| H4-02 | Description: Fusing section low temperature trouble (HL3) The set temperature is not reached within the specified time (normally 3 min or 5 min in the curl prevention mode) after turning on the power relay. When the heater lamp is not turned off in 4 min |
| F2-02 | Description: Toner supply abnormality Toner remains in the toner bottle when undertoner is detected by the toner concentration sensor in the developing unit. |
| E7-67 | Description: Incompatibility check (70ppm) (MFP controller detection) An error is detected in the internal incompatibility check in the MFP control PWB. |
| F3-12 | Description: Machine tray 1 lift-up trouble PED does not turn on within the specified time. LUD does not turn on within the specified time. The trouble occurs 3 times continuously that the upper limit sensor does not turn on by lift-up operation for 21se |
