These results are ranked by popularity.
| Error | |
|---|---|
| F6-88 | Description: FAX board communication trouble (Time out).FAX board communication error. |
| CH-Blink | Description: Developing cartridge not installedThe developing cartridge is not installed. Communication with the CRUM cannot be made in initial check of the CRUM. |
| L8-01 | Description: No full wave signal.The zero cross signal is not detected. |
| F2-64 | Description: Toner supply abnormality When toner near end is detected with the toner supply time of 50% or less. When the toner supply time exceeds 300%. |
| H3-00 | Description: Heat roller high temperature detection (MAIN)The fusing temperature exceeds 245C°. |
The most common error codes.
| Error | |
|---|---|
| F6-88 | Description: FAX board communication trouble (Time out).FAX board communication error. |
| CH-Blink | Description: Developing cartridge not installedThe developing cartridge is not installed. Communication with the CRUM cannot be made in initial check of the CRUM. |
| L8-01 | Description: No full wave signal.The zero cross signal is not detected. |
| F2-64 | Description: Toner supply abnormality When toner near end is detected with the toner supply time of 50% or less. When the toner supply time exceeds 300%. |
| H3-00 | Description: Heat roller high temperature detection (MAIN)The fusing temperature exceeds 245C°. |
| F6-88 | Description: FAX board communication trouble (Time out).FAX board communication error. |
| CH-Blink | Description: Developing cartridge not installedThe developing cartridge is not installed. Communication with the CRUM cannot be made in initial check of the CRUM. |
| L8-01 | Description: No full wave signal.The zero cross signal is not detected. |
| F2-64 | Description: Toner supply abnormality When toner near end is detected with the toner supply time of 50% or less. When the toner supply time exceeds 300%. |
| H3-00 | Description: Heat roller high temperature detection (MAIN)The fusing temperature exceeds 245C°. |
