Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp AR317FG Top Searches

These results are ranked by popularity.

Error
F1-53Description: Interface transport unit connection trouble Interface transport unit connector disconnection
U9-88Description: Operation control PWB communication trouble (Time-out) Communication trouble between MCU and the operation PWB (Time-out error)
F1-00Description: Finisher communication trouble Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in Finisher communication
F1-31Description: Fold sensor trouble Sensor input value abnormality
H4-20Description: Main heater lamp abnormally low temperature detection The setup temperature (about 25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning on the power ON SW. (When the temperature falls below 140°C in the stand

Sharp AR317FG Common Errors

The most common error codes.

Error
F1-53Description: Interface transport unit connection trouble Interface transport unit connector disconnection
U9-88Description: Operation control PWB communication trouble (Time-out) Communication trouble between MCU and the operation PWB (Time-out error)
F1-00Description: Finisher communication trouble Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in Finisher communication
F1-31Description: Fold sensor trouble Sensor input value abnormality
H4-20Description: Main heater lamp abnormally low temperature detection The setup temperature (about 25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning on the power ON SW. (When the temperature falls below 140°C in the stand
F1-53Description: Interface transport unit connection trouble Interface transport unit connector disconnection
U9-88Description: Operation control PWB communication trouble (Time-out) Communication trouble between MCU and the operation PWB (Time-out error)
F1-00Description: Finisher communication trouble Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in Finisher communication
F1-31Description: Fold sensor trouble Sensor input value abnormality
H4-20Description: Main heater lamp abnormally low temperature detection The setup temperature (about 25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning on the power ON SW. (When the temperature falls below 140°C in the stand