Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh SPC440DN Top Searches

These results are ranked by popularity.

Error
364Description: TD sensor (Vt low) error 2: K. The Vt value of the black, magenta, cyan, or yellow TD sensor is below the specified value with SP3020-004 (default: 0.5V) ten counts.
540Description: Fusing/Paper exit motor error The BCU receives the lock signal 2.0 seconds after turning on the fusing/paper exit motor.
855-02Description: Wireless LAN card error 2 CTL A problem occurred when the Wireless LAN device was not initialized at power on.
452Description: PTR (Paper Transfer Roller) contact error The PTR contact sensor does not detect the movement of actuator at the sensor while the polygon motor rotates.
559Description: Consecutive fusing jam The paper jam counter for the fusing unit reaches 3 times. The paper jam counter is cleared if the paper is fed correctly. This SC is activated only when SP1159-001 is set to "1" (default "0").

Ricoh SPC440DN Common Errors

The most common error codes.

Error
364Description: TD sensor (Vt low) error 2: K. The Vt value of the black, magenta, cyan, or yellow TD sensor is below the specified value with SP3020-004 (default: 0.5V) ten counts.
540Description: Fusing/Paper exit motor error The BCU receives the lock signal 2.0 seconds after turning on the fusing/paper exit motor.
855-02Description: Wireless LAN card error 2 CTL A problem occurred when the Wireless LAN device was not initialized at power on.
452Description: PTR (Paper Transfer Roller) contact error The PTR contact sensor does not detect the movement of actuator at the sensor while the polygon motor rotates.
559Description: Consecutive fusing jam The paper jam counter for the fusing unit reaches 3 times. The paper jam counter is cleared if the paper is fed correctly. This SC is activated only when SP1159-001 is set to "1" (default "0").
364Description: TD sensor (Vt low) error 2: K. The Vt value of the black, magenta, cyan, or yellow TD sensor is below the specified value with SP3020-004 (default: 0.5V) ten counts.
540Description: Fusing/Paper exit motor error The BCU receives the lock signal 2.0 seconds after turning on the fusing/paper exit motor.
855-02Description: Wireless LAN card error 2 CTL A problem occurred when the Wireless LAN device was not initialized at power on.
452Description: PTR (Paper Transfer Roller) contact error The PTR contact sensor does not detect the movement of actuator at the sensor while the polygon motor rotates.
559Description: Consecutive fusing jam The paper jam counter for the fusing unit reaches 3 times. The paper jam counter is cleared if the paper is fed correctly. This SC is activated only when SP1159-001 is set to "1" (default "0").