These results are ranked by popularity.
Error | |
---|---|
547 | Description: Zero cross error The zero cross signal is detected three times even though the heater relay is off when turning on the main power. The zero cross signal is not detected for three seconds even though the heater relay is on after turning on th |
305 | Description: Charge AC bias error [M] The charge current less than 200 mkA is detected. |
875 | Description: Delete All error 2: Data area An error is detected while the all data of the HDD or NVRAM are formatted logically by the Data Overwrite Security Unit (B735). |
371 | Description: TD sensor: Initial control voltage error [Y] Vt is less than 1 V even though the control power voltage is adjusted to the maximum. Vt is more than 1 V even though the control power voltage is adjusted to the minimum. |
222 | Description: Leading edge laser detection error: [Y] The laser synchronizing detection signal for LDB [Y] of the leading edge is not output for two seconds after LDB unit turns on while the polygon motor is rotating normally. |
The most common error codes.
Error | |
---|---|
547 | Description: Zero cross error The zero cross signal is detected three times even though the heater relay is off when turning on the main power. The zero cross signal is not detected for three seconds even though the heater relay is on after turning on th |
305 | Description: Charge AC bias error [M] The charge current less than 200 mkA is detected. |
875 | Description: Delete All error 2: Data area An error is detected while the all data of the HDD or NVRAM are formatted logically by the Data Overwrite Security Unit (B735). |
371 | Description: TD sensor: Initial control voltage error [Y] Vt is less than 1 V even though the control power voltage is adjusted to the maximum. Vt is more than 1 V even though the control power voltage is adjusted to the minimum. |
222 | Description: Leading edge laser detection error: [Y] The laser synchronizing detection signal for LDB [Y] of the leading edge is not output for two seconds after LDB unit turns on while the polygon motor is rotating normally. |
547 | Description: Zero cross error The zero cross signal is detected three times even though the heater relay is off when turning on the main power. The zero cross signal is not detected for three seconds even though the heater relay is on after turning on th |
305 | Description: Charge AC bias error [M] The charge current less than 200 mkA is detected. |
875 | Description: Delete All error 2: Data area An error is detected while the all data of the HDD or NVRAM are formatted logically by the Data Overwrite Security Unit (B735). |
371 | Description: TD sensor: Initial control voltage error [Y] Vt is less than 1 V even though the control power voltage is adjusted to the maximum. Vt is more than 1 V even though the control power voltage is adjusted to the minimum. |
222 | Description: Leading edge laser detection error: [Y] The laser synchronizing detection signal for LDB [Y] of the leading edge is not output for two seconds after LDB unit turns on while the polygon motor is rotating normally. |