Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh SPC400DN Top Searches

These results are ranked by popularity.

Error
875Description: Delete All error 2: Data area An error is detected while the all data of the HDD or NVRAM are formatted logically by the Data Overwrite Security Unit (B735).
547Description: Zero cross error The zero cross signal is detected three times even though the heater relay is off when turning on the main power. The zero cross signal is not detected for three seconds even though the heater relay is on after turning on th
305Description: Charge AC bias error [M] The charge current less than 200 mkA is detected.
827Description: Self-diagnostic Error: RAM
371Description: TD sensor: Initial control voltage error [Y] Vt is less than 1 V even though the control power voltage is adjusted to the maximum. Vt is more than 1 V even though the control power voltage is adjusted to the minimum.

Ricoh SPC400DN Common Errors

The most common error codes.

Error
875Description: Delete All error 2: Data area An error is detected while the all data of the HDD or NVRAM are formatted logically by the Data Overwrite Security Unit (B735).
547Description: Zero cross error The zero cross signal is detected three times even though the heater relay is off when turning on the main power. The zero cross signal is not detected for three seconds even though the heater relay is on after turning on th
305Description: Charge AC bias error [M] The charge current less than 200 mkA is detected.
827Description: Self-diagnostic Error: RAM
371Description: TD sensor: Initial control voltage error [Y] Vt is less than 1 V even though the control power voltage is adjusted to the maximum. Vt is more than 1 V even though the control power voltage is adjusted to the minimum.
875Description: Delete All error 2: Data area An error is detected while the all data of the HDD or NVRAM are formatted logically by the Data Overwrite Security Unit (B735).
547Description: Zero cross error The zero cross signal is detected three times even though the heater relay is off when turning on the main power. The zero cross signal is not detected for three seconds even though the heater relay is on after turning on th
305Description: Charge AC bias error [M] The charge current less than 200 mkA is detected.
827Description: Self-diagnostic Error: RAM
371Description: TD sensor: Initial control voltage error [Y] Vt is less than 1 V even though the control power voltage is adjusted to the maximum. Vt is more than 1 V even though the control power voltage is adjusted to the minimum.