Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh SPC361SFNw Top Searches

These results are ranked by popularity.

Error
SC845-51Description: Hardware Error Detected when the automatic firmware update Network error, DIMM error (For the MF models only) Unzipping the firmware package file downloaded via the ARFU, the application site, or the SFU failed.
SC491-02Description: Disconnected connector: High voltage output error The "HVP_ERR2: Output error Sensor signal" is monitored at 20 ms intervals. If 0 (error) is detected ten times in succession (200 ms) (during non-bias output), the following causes are suspec
SC571-00Description: Broken pressure (End) thermistor wire At least ten times, the temperature is detected to stay at 0 deg C or less for 39 seconds.
SC144-00Description: Scanner Communication Error: Front Side Cannot correctly establish communication with the MPU(SoC-AFE)
SC542-14Description: Fusing lamp (Center) thermopile not reloaded 3: Low voltage The heater (Center) thermistor does not reach 100 deg C 7.7 seconds after the start of heat control (during low-temperature start up control).

Ricoh SPC361SFNw Common Errors

The most common error codes.

Error
SC845-51Description: Hardware Error Detected when the automatic firmware update Network error, DIMM error (For the MF models only) Unzipping the firmware package file downloaded via the ARFU, the application site, or the SFU failed.
SC491-02Description: Disconnected connector: High voltage output error The "HVP_ERR2: Output error Sensor signal" is monitored at 20 ms intervals. If 0 (error) is detected ten times in succession (200 ms) (during non-bias output), the following causes are suspec
SC571-00Description: Broken pressure (End) thermistor wire At least ten times, the temperature is detected to stay at 0 deg C or less for 39 seconds.
SC144-00Description: Scanner Communication Error: Front Side Cannot correctly establish communication with the MPU(SoC-AFE)
SC542-14Description: Fusing lamp (Center) thermopile not reloaded 3: Low voltage The heater (Center) thermistor does not reach 100 deg C 7.7 seconds after the start of heat control (during low-temperature start up control).
SC845-51Description: Hardware Error Detected when the automatic firmware update Network error, DIMM error (For the MF models only) Unzipping the firmware package file downloaded via the ARFU, the application site, or the SFU failed.
SC491-02Description: Disconnected connector: High voltage output error The "HVP_ERR2: Output error Sensor signal" is monitored at 20 ms intervals. If 0 (error) is detected ten times in succession (200 ms) (during non-bias output), the following causes are suspec
SC571-00Description: Broken pressure (End) thermistor wire At least ten times, the temperature is detected to stay at 0 deg C or less for 39 seconds.
SC144-00Description: Scanner Communication Error: Front Side Cannot correctly establish communication with the MPU(SoC-AFE)
SC542-14Description: Fusing lamp (Center) thermopile not reloaded 3: Low voltage The heater (Center) thermistor does not reach 100 deg C 7.7 seconds after the start of heat control (during low-temperature start up control).