Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh SP5200S Top Searches

These results are ranked by popularity.

Error
440Description: Transfer roller leak error 1 A transfer roller current leak signal wad detected higher or lower than 50% for 200 ms. (The current feedback signal for the transfer roller was not detected within the correct time.)
877Description: Data Overwrite Security SD card error The 'all delete' function did not execute but the Data Overwrite Security Unit (D362) is installed and activated.
721Description: Front fence motor error The jogger fence motor in the finisher is not operating.
544Description: Fusing overheat error 2 (center) A fusing temperature over 250°C is detected at the center of the hot roller by the fusing temperature monitor circuit in the BCU board.
998Description: Application start error No applications start within 60 sec. after the power is turned on.

Ricoh SP5200S Common Errors

The most common error codes.

Error
440Description: Transfer roller leak error 1 A transfer roller current leak signal wad detected higher or lower than 50% for 200 ms. (The current feedback signal for the transfer roller was not detected within the correct time.)
877Description: Data Overwrite Security SD card error The 'all delete' function did not execute but the Data Overwrite Security Unit (D362) is installed and activated.
721Description: Front fence motor error The jogger fence motor in the finisher is not operating.
544Description: Fusing overheat error 2 (center) A fusing temperature over 250°C is detected at the center of the hot roller by the fusing temperature monitor circuit in the BCU board.
998Description: Application start error No applications start within 60 sec. after the power is turned on.
440Description: Transfer roller leak error 1 A transfer roller current leak signal wad detected higher or lower than 50% for 200 ms. (The current feedback signal for the transfer roller was not detected within the correct time.)
877Description: Data Overwrite Security SD card error The 'all delete' function did not execute but the Data Overwrite Security Unit (D362) is installed and activated.
721Description: Front fence motor error The jogger fence motor in the finisher is not operating.
544Description: Fusing overheat error 2 (center) A fusing temperature over 250°C is detected at the center of the hot roller by the fusing temperature monitor circuit in the BCU board.
998Description: Application start error No applications start within 60 sec. after the power is turned on.