Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh PC600 Top Searches

These results are ranked by popularity.

Error
SC878-01Description: USB flash error There is a problem in the file system of the USB flash memory.
SC689-01Description: EEPROM Communication Error 1 • No response from the device in reading/writing for 5 seconds or more and this problem is repeated 5 times. • The reading data of 2 locations does not match 8 times consecutively. • The writing data and reading
SC501-01Description: Paper Feed Tray Lift Motor (M9) Error (Tray 1) After installing paper feed tray 1, either of the following 1 to 4 is detected 5 times continuously. 1. The lift motor (M9) excess current is detected for 80 ms. 2. The lift sensor does not turn
SC332-01Description: Toner motor (M11) error (black) The excess current signal was detected for 5 seconds continuously.
SC547-00Description: Zero-cross signal error The zero-cross signal is not input for 1 second continuously when the fusing heater turns on and the 24 V broken wire is not detected.

Ricoh PC600 Common Errors

The most common error codes.

Error
SC878-01Description: USB flash error There is a problem in the file system of the USB flash memory.
SC689-01Description: EEPROM Communication Error 1 • No response from the device in reading/writing for 5 seconds or more and this problem is repeated 5 times. • The reading data of 2 locations does not match 8 times consecutively. • The writing data and reading
SC501-01Description: Paper Feed Tray Lift Motor (M9) Error (Tray 1) After installing paper feed tray 1, either of the following 1 to 4 is detected 5 times continuously. 1. The lift motor (M9) excess current is detected for 80 ms. 2. The lift sensor does not turn
SC332-01Description: Toner motor (M11) error (black) The excess current signal was detected for 5 seconds continuously.
SC547-00Description: Zero-cross signal error The zero-cross signal is not input for 1 second continuously when the fusing heater turns on and the 24 V broken wire is not detected.
SC878-01Description: USB flash error There is a problem in the file system of the USB flash memory.
SC689-01Description: EEPROM Communication Error 1 • No response from the device in reading/writing for 5 seconds or more and this problem is repeated 5 times. • The reading data of 2 locations does not match 8 times consecutively. • The writing data and reading
SC501-01Description: Paper Feed Tray Lift Motor (M9) Error (Tray 1) After installing paper feed tray 1, either of the following 1 to 4 is detected 5 times continuously. 1. The lift motor (M9) excess current is detected for 80 ms. 2. The lift sensor does not turn
SC332-01Description: Toner motor (M11) error (black) The excess current signal was detected for 5 seconds continuously.
SC547-00Description: Zero-cross signal error The zero-cross signal is not input for 1 second continuously when the fusing heater turns on and the 24 V broken wire is not detected.