Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh P801 Top Searches

These results are ranked by popularity.

Error
SC900-00Description: Electric counter error The electric total counter value is out of specification. Error is detected when increasing the total counter.
SC396-02Description: Drum Motor (M6) Error 2 After the drum motor (M6) is stabilized, the stable OFF signal is detected for 2 seconds consecutively.
SC668-03Description: IOB (PCB17) Communication Error: Retry Timeout Error Operation does not resume in 10 seconds after an error occurs.
SC842-02Description: Number of Nand-Flash block deletions exceeded At startup, or when the machined returned from energy save mode, the Nand- Flash was read and judged that the number of deleted blocks had exceeded threshold, and then SCS generated this SC code.
SC101-01Description: Lamp Error (Scanning) The white level peak did not reach the prescribed threshold when the white guide plate was scanned. Error detection timing; • During a scan from the exposure glass: When the scanning of the white guide plate is complete

Ricoh P801 Common Errors

The most common error codes.

Error
SC900-00Description: Electric counter error The electric total counter value is out of specification. Error is detected when increasing the total counter.
SC396-02Description: Drum Motor (M6) Error 2 After the drum motor (M6) is stabilized, the stable OFF signal is detected for 2 seconds consecutively.
SC668-03Description: IOB (PCB17) Communication Error: Retry Timeout Error Operation does not resume in 10 seconds after an error occurs.
SC842-02Description: Number of Nand-Flash block deletions exceeded At startup, or when the machined returned from energy save mode, the Nand- Flash was read and judged that the number of deleted blocks had exceeded threshold, and then SCS generated this SC code.
SC101-01Description: Lamp Error (Scanning) The white level peak did not reach the prescribed threshold when the white guide plate was scanned. Error detection timing; • During a scan from the exposure glass: When the scanning of the white guide plate is complete
SC900-00Description: Electric counter error The electric total counter value is out of specification. Error is detected when increasing the total counter.
SC396-02Description: Drum Motor (M6) Error 2 After the drum motor (M6) is stabilized, the stable OFF signal is detected for 2 seconds consecutively.
SC668-03Description: IOB (PCB17) Communication Error: Retry Timeout Error Operation does not resume in 10 seconds after an error occurs.
SC842-02Description: Number of Nand-Flash block deletions exceeded At startup, or when the machined returned from energy save mode, the Nand- Flash was read and judged that the number of deleted blocks had exceeded threshold, and then SCS generated this SC code.
SC101-01Description: Lamp Error (Scanning) The white level peak did not reach the prescribed threshold when the white guide plate was scanned. Error detection timing; • During a scan from the exposure glass: When the scanning of the white guide plate is complete