Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MPW7140 Top Searches

These results are ranked by popularity.

Error
SC641Description: Engine-to-controller communication error: No response GW The controller sent a frame to the main machine engine but there was no response as demanded by RAPI protocol. The frame was sent 3 times at 100 ms intervals. This SC was issued after
SC866Description: SD card error 1: Recognition error GW The SD card mounted in the slot contains illegal program data.
SC506Description: Cassette feed motor error The cassette feed motor lock signal remained HIGH longer than 2 sec. during operation. Note: When this SC occurs, paper feed from the cassette is not possible. However, roll paper can feed from tray 1 and tray 2.
SC551Description: Pressure roller center thermistor error 1 The thermistor returned temperature readings less than 5°C (41°F) for 12 sec. during fusing temperature control while the hot roller and pressure rollers were rotating
SC764Description: Cross folder fold plate HP sensor (U) error The state (on/off) of the upper fold plate HP sensor did not change within 1 sec. after the fold plate motor (U) switched on

Ricoh MPW7140 Common Errors

The most common error codes.

Error
SC641Description: Engine-to-controller communication error: No response GW The controller sent a frame to the main machine engine but there was no response as demanded by RAPI protocol. The frame was sent 3 times at 100 ms intervals. This SC was issued after
SC866Description: SD card error 1: Recognition error GW The SD card mounted in the slot contains illegal program data.
SC506Description: Cassette feed motor error The cassette feed motor lock signal remained HIGH longer than 2 sec. during operation. Note: When this SC occurs, paper feed from the cassette is not possible. However, roll paper can feed from tray 1 and tray 2.
SC551Description: Pressure roller center thermistor error 1 The thermistor returned temperature readings less than 5°C (41°F) for 12 sec. during fusing temperature control while the hot roller and pressure rollers were rotating
SC764Description: Cross folder fold plate HP sensor (U) error The state (on/off) of the upper fold plate HP sensor did not change within 1 sec. after the fold plate motor (U) switched on
SC641Description: Engine-to-controller communication error: No response GW The controller sent a frame to the main machine engine but there was no response as demanded by RAPI protocol. The frame was sent 3 times at 100 ms intervals. This SC was issued after
SC866Description: SD card error 1: Recognition error GW The SD card mounted in the slot contains illegal program data.
SC506Description: Cassette feed motor error The cassette feed motor lock signal remained HIGH longer than 2 sec. during operation. Note: When this SC occurs, paper feed from the cassette is not possible. However, roll paper can feed from tray 1 and tray 2.
SC551Description: Pressure roller center thermistor error 1 The thermistor returned temperature readings less than 5°C (41°F) for 12 sec. during fusing temperature control while the hot roller and pressure rollers were rotating
SC764Description: Cross folder fold plate HP sensor (U) error The state (on/off) of the upper fold plate HP sensor did not change within 1 sec. after the fold plate motor (U) switched on