Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MPC7500SP Top Searches

These results are ranked by popularity.

Error
SC546Description: Heating roller thermistor error (side) The temperature measured by the heating roller thermistor does not reach 0°C after 50 sec. and remains over this temperature for 10 readings.
SC721Description: Finisher jogger motor error (D373/D374, B830) The jogger fences move out of the home position but the HP sensor output does not change within the specified number of pulses. The 1st failure causes an original jam message, and the 2nd failur
SC422Description: Potential sensor error: Vd Adjustment M The development potential of the drum before exposure (Vd) cannot be adjusted to within +-8 V of the target voltage (-900V).
SC770Description: Cover Interposer Lift Motor 1 Error In the first tray: • The upper limit sensor did not detect the bottom plate within the specified time after the lift motor switched on to lift the bottom plate. • The lower limit sensor did not direct the
SC925Description: Net File function error The NetFile file management on the HDD cannot be used, or a NetFile management file is corrupted and operation cannot continue. The HDDs are defective and they cannot be debugged or partitioned, so the Scan Router fu

Ricoh MPC7500SP Common Errors

The most common error codes.

Error
SC546Description: Heating roller thermistor error (side) The temperature measured by the heating roller thermistor does not reach 0°C after 50 sec. and remains over this temperature for 10 readings.
SC721Description: Finisher jogger motor error (D373/D374, B830) The jogger fences move out of the home position but the HP sensor output does not change within the specified number of pulses. The 1st failure causes an original jam message, and the 2nd failur
SC422Description: Potential sensor error: Vd Adjustment M The development potential of the drum before exposure (Vd) cannot be adjusted to within +-8 V of the target voltage (-900V).
SC770Description: Cover Interposer Lift Motor 1 Error In the first tray: • The upper limit sensor did not detect the bottom plate within the specified time after the lift motor switched on to lift the bottom plate. • The lower limit sensor did not direct the
SC925Description: Net File function error The NetFile file management on the HDD cannot be used, or a NetFile management file is corrupted and operation cannot continue. The HDDs are defective and they cannot be debugged or partitioned, so the Scan Router fu
SC546Description: Heating roller thermistor error (side) The temperature measured by the heating roller thermistor does not reach 0°C after 50 sec. and remains over this temperature for 10 readings.
SC721Description: Finisher jogger motor error (D373/D374, B830) The jogger fences move out of the home position but the HP sensor output does not change within the specified number of pulses. The 1st failure causes an original jam message, and the 2nd failur
SC422Description: Potential sensor error: Vd Adjustment M The development potential of the drum before exposure (Vd) cannot be adjusted to within +-8 V of the target voltage (-900V).
SC483Description: Drum cleaning motor error: Y The drum cleaning motor failed to switch on (motor lock), or failed to reach the required speed within the prescribed time.
SC337Description: Developer set error: M The value of Vcnt is set at the maximum or minimum setting when the TD sensor is initialized.