Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MPC6501 Top Searches

These results are ranked by popularity.

Error
SC195Description: Machine serial number error The number registered for the machine serial number does not match.
SC792-12Description: Alignment pin error Not detected at HP after the time prescribed to arrive at the HP had elapsed (more than 400 ms) (1st detection, jam, 2nd detection, SC error) -or- Detected at HP after the time prescribed to leave the HP had elapsed (mor
SC870Description: Address book data error Address book data on the hard disk was detected as abnormal when it was accessed from either the operation panel or the network. The address book data cannot be read from the HDD or SD card where it is stored, or the
SC767Description: Stack Junction Gate Motor (D373) The stack junction gate did not return to the home position within the specified time.
SC551Description: Pressure roller thermistor error 1 The temperature measured by the pressure roller thermistor did not reach 0°C after 10 attempts.

Ricoh MPC6501 Common Errors

The most common error codes.

Error
SC195Description: Machine serial number error The number registered for the machine serial number does not match.
SC792-12Description: Alignment pin error Not detected at HP after the time prescribed to arrive at the HP had elapsed (more than 400 ms) (1st detection, jam, 2nd detection, SC error) -or- Detected at HP after the time prescribed to leave the HP had elapsed (mor
SC870Description: Address book data error Address book data on the hard disk was detected as abnormal when it was accessed from either the operation panel or the network. The address book data cannot be read from the HDD or SD card where it is stored, or the
SC767Description: Stack Junction Gate Motor (D373) The stack junction gate did not return to the home position within the specified time.
SC551Description: Pressure roller thermistor error 1 The temperature measured by the pressure roller thermistor did not reach 0°C after 10 attempts.
SC195Description: Machine serial number error The number registered for the machine serial number does not match.
SC424Description: Potential sensor error 5: Vl adjustment K Vpl could not be adjusted to within +-5V of the target Vpl after exposure of the ID sensor patterns.
SC551Description: Pressure roller thermistor error 1 The temperature measured by the pressure roller thermistor did not reach 0°C after 10 attempts.
SC365Description: TD sensor (Vt low) error: M The Vt value of the black, magenta, cyan, or yellow TD sensor is below 0.5V for 10 counts.
SC792-12Description: Alignment pin error Not detected at HP after the time prescribed to arrive at the HP had elapsed (more than 400 ms) (1st detection, jam, 2nd detection, SC error) -or- Detected at HP after the time prescribed to leave the HP had elapsed (mor