Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MPC4502 Top Searches

These results are ranked by popularity.

Error
874Description: Delete All error: Data area A data error is detected for the HDD/NVRAM after the Delete All option has been used. Note: The source of this error is the Data Overwrite Security Unit running from an SD card.
396-02Description: Drum/Development motor error: C The machine detects a High signal from the drum/development motor for 2 seconds after the drum/development motor turned on.
722-17Description: Paper feed motor error: inner tray Motor driver error signal is output.
230-01Description: FGATE ON error: K The PFGATE ON signal does not assert within 5 seconds after processing the image in normal job or MUSIC for start position [K], [C], [M], [Y].
544Description: Heating roller overheat: Center (hardware error) During stand-by mode or a print job, the detected heating roller temperature reaches 220°C.

Ricoh MPC4502 Common Errors

The most common error codes.

Error
874Description: Delete All error: Data area A data error is detected for the HDD/NVRAM after the Delete All option has been used. Note: The source of this error is the Data Overwrite Security Unit running from an SD card.
396-02Description: Drum/Development motor error: C The machine detects a High signal from the drum/development motor for 2 seconds after the drum/development motor turned on.
722-17Description: Paper feed motor error: inner tray Motor driver error signal is output.
230-01Description: FGATE ON error: K The PFGATE ON signal does not assert within 5 seconds after processing the image in normal job or MUSIC for start position [K], [C], [M], [Y].
544Description: Heating roller overheat: Center (hardware error) During stand-by mode or a print job, the detected heating roller temperature reaches 220°C.
230-01Description: FGATE ON error: K The PFGATE ON signal does not assert within 5 seconds after processing the image in normal job or MUSIC for start position [K], [C], [M], [Y].
544Description: Heating roller overheat: Center (hardware error) During stand-by mode or a print job, the detected heating roller temperature reaches 220°C.
396-02Description: Drum/Development motor error: C The machine detects a High signal from the drum/development motor for 2 seconds after the drum/development motor turned on.
650Description: Communication error of the remote service modem (Cumin-M)
722-17Description: Paper feed motor error: inner tray Motor driver error signal is output.