Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MPC4500 Top Searches

These results are ranked by popularity.

Error
670Description: No response from controller at power on When the main power is turned on or the machine starts warming up from energysaving mode, the controller does not receive a command signal from the controller.
223Description: Laser synchronizing detection error: start position [Y]: LD1 The laser synchronizing detection signal for the start position of the LDB [K], [Y], [M], [C] is not output for two seconds after LDB unit turns on while the polygon motor is rotat
544Description: Heating roller overheat 1 (hardware error) During stand-by mode or a print job, the detected heating roller temperature reaches 220 °C.
367Description: TD sensor (Vt high) error 2: Y The Vt value of the black, magenta, cyan, or yellow TD sensor is below the specified value with SP3020-004 (default: 0.5V) for 10 counts.
851Description: IEEE1394 interface error The 1394 interface is unusable.

Ricoh MPC4500 Common Errors

The most common error codes.

Error
670Description: No response from controller at power on When the main power is turned on or the machine starts warming up from energysaving mode, the controller does not receive a command signal from the controller.
223Description: Laser synchronizing detection error: start position [Y]: LD1 The laser synchronizing detection signal for the start position of the LDB [K], [Y], [M], [C] is not output for two seconds after LDB unit turns on while the polygon motor is rotat
544Description: Heating roller overheat 1 (hardware error) During stand-by mode or a print job, the detected heating roller temperature reaches 220 °C.
367Description: TD sensor (Vt high) error 2: Y The Vt value of the black, magenta, cyan, or yellow TD sensor is below the specified value with SP3020-004 (default: 0.5V) for 10 counts.
851Description: IEEE1394 interface error The 1394 interface is unusable.
670Description: No response from controller at power on When the main power is turned on or the machine starts warming up from energysaving mode, the controller does not receive a command signal from the controller.
223Description: Laser synchronizing detection error: start position [Y]: LD1 The laser synchronizing detection signal for the start position of the LDB [K], [Y], [M], [C] is not output for two seconds after LDB unit turns on while the polygon motor is rotat
544Description: Heating roller overheat 1 (hardware error) During stand-by mode or a print job, the detected heating roller temperature reaches 220 °C.
367Description: TD sensor (Vt high) error 2: Y The Vt value of the black, magenta, cyan, or yellow TD sensor is below the specified value with SP3020-004 (default: 0.5V) for 10 counts.
851Description: IEEE1394 interface error The 1394 interface is unusable.